Your cart is empty.
Your cart is empty.IdeaFormer-3D Smooth H1H Build Plate for Creality K1 Max, Ender 3 V3 Plus Double Sided Rainbow Streak+Phantom H1H Spring Steel Bed Plate Flexible K1 Max Sheet 315x310 mm No Magnetic Plate
agustin
Reviewed in the United States on February 1, 2025
love the design of the pattern
mnq
Reviewed in the United States on January 4, 2025
I print a lot of large pieces and these plates are fantastic. ABS sticks like glue (minus glue) and every type of PLA sticks to the smooth side with just a light rubdown of glue (3D printer specific). The smooth side leaves a pattern on the prints that just looks cool so you have functional, and fun 🤩.I bought two because as soon as one job ends I just swap the plates and run the next batch. Never had any issue with release either if you take the time to let the plates cool (which is the reason I bought two).Will 100% buy these again but after almost 100 prints they show zero wear so I don’t see needing to replace these anytime soon.For specifics I use these on an Ender 3 v3 Plus running anywhere between 65 and 100 degrees for the bed temp and 275mm/s to 600mm/s speeds.
Geobig
Reviewed in Canada on January 25, 2025
Good quality product. Works better then the original Creality build plate nice to have the PEO side for PLA prints that need a smoother bottom layer.
Joe D.
Reviewed in the United States on January 14, 2025
With these build plates you do need good adhesion. If you need any glue stick or anything like that, it’ll ruin the holographic results.For me, pla adhered well and the k1 did everything automatically.Cool effect, not sure how long it’ll last, but it has worked after about 6 prints.
robin rozzelle
Reviewed in the United States on September 24, 2024
I ordered this for a specific printer and the slots in the back arent even close. Other than that works Ok so far.Contacted them about the problem and promtly made it right . THANKS
David McFarland
Reviewed in the United States on August 18, 2024
The media could not be loaded.
Melissa
Reviewed in Canada on July 20, 2024
Requires glue won't stick to bed completely but does print out nicely 👌
Oliver
Reviewed in Canada on December 31, 2024
The pattern transfers on to the print fine, and it fits my K1 MAX perfectly. However, it is difficult to get the prints to adhere to the plate. Lots of failed prints and wasted filament.
Drey Digital
Reviewed in the United States on November 25, 2024
Adhesion is amazing and love the effect that it gives!
F.
Reviewed in Canada on November 16, 2024
Works great, durability im not sure as its not my main plate.Adhesion is good.
Kody
Reviewed in the United States on October 16, 2024
Works as advertised and is the same or better quality as the stock plate super easy to remove stuff and have had no adhesive issues whatsoever with a little bed adhesive . Leaves the texture on the prints looks so cool great product
Blair Diaz
Reviewed in the United States on October 12, 2024
I got this because my OEM build plate was getting worn out. I use Elegoos rapid pla + and it sticks just fine I'm very happy.
Recommended Products
