Your cart is empty.
Your cart is empty.Product Description
:-) maker!
Reviewed in the United States on January 31, 2025
Cut through some quarter inch plate in no time. Worth it. I need to buy another.
Adam Lesser
Reviewed in the United States on September 9, 2024
Unlike many of the cheap Chinese bits you can buy that are just total garbage and are not even sharp when they arrive at your door these bits are different, they are up to reasonably good standard without being exceedingly overly priced. These are the bits you want if you’re looking for the middle ground between the high-end bits and the ones that are so bad they’re painful to use
Ross
Reviewed in Australia on September 13, 2024
Love this step drill. Should have bought one years ago. Drilled a variety of mild steel materials and saved me loads of time
Chris Li
Reviewed in the United States on March 3, 2024
This step drill makes it very easy to cut through the stainless steel.
Dean A. Burrell
Reviewed in the United States on November 29, 2024
I’ve not used it yet but appears to be of good quality but time will tell.
avar28
Reviewed in the United States on November 17, 2024
After watching PF’s review video, I ended up buying this and it has worked like a charm. I’m so impressed I bought a 2nd one as a backup!
Steve Phillips
Reviewed in Australia on July 5, 2023
I drilled several full width holes in 1/2" steel plate, no problemo.Very happy with this drill bit.
Garrett
Reviewed in the United States on July 17, 2023
Havnt used yet, looks nice though
Bradley P.
Reviewed in the United States on August 18, 2022
I used this to drill through some stainless around 1/16th of an inch thick. It's some hard stainless, a bosch cobalt bit had no chance. However, I drilled a pilot with another bit and then put this step drill bit in the hole and it carved through the stainless like it was butter. Just unbelievably sharp and easy, I was elated.
ADW
Reviewed in the United States on May 6, 2018
Good sharp bit! We had to ream out a batch of laser cut 3mm stainless, 18-8, and dropped the drill speed way down (500 is the lowest it will go on this press) and used a moderate amount of cutting oil applied between each part change (2 holes) Cut perfect, no stalling, minimal heat buildup.If you are having trouble cutting stainless, slow the drill down. You want uniform chips. If you are not getting small curls, and a lot of smoke, get the 500lb gorilla off the drill and apply some finesse.Quality bit, will buy this brand again.
Exzacklee
Reviewed in Canada on November 13, 2018
Good quality. Nice and sharp. Drills well and clean hole
Recommended Products
$19.95
$ 7 .99 $7.99