Your cart is empty.
Your cart is empty.Gary Tinker
Reviewed in the United States on September 1, 2024
Works well, easy to install.
Chris D.
Reviewed in Canada on July 10, 2023
Looks like an exact replacement and was easy to install. Fit and worked perfectly!
Jane MacFarlane
Reviewed in the United States on June 6, 2023
Easy to install works great with the wireless remote for my ceiling fan.
Alejandro
Reviewed in Mexico on November 10, 2023
Compre esta pieza para remplazar la que originalmente venia con mi ventilador, y funciona perfecto, se sincroniza con el control y muy fácil de instalar.
Pops
Reviewed in the United States on August 31, 2019
This replaced a Hampton Bay 7067FM - 15 (5 + 6) receiver that was paired with Hampton Bay remote transmitter UC7078T (both original parts to the fan). It did not work correctly with the original UC7078T remote, so I had to then buy the replacement for the UC7078T (https://www.amazon.com/gp/product/B01BMN4WGG/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1), and now everything works perfectly.
Shawn T Johnson
Reviewed in the United States on May 10, 2018
Purchased this product to repair a remote controlled fan made by Hampton Bay. The part I removed would activate the fan, but not the light. When I installed this product, the fan & light did nothing at all. The remote was confirmed to be good & the light bulbs were confirmed to be good. The dip switches matched as well. Simply didn't work out of the box.
Dr. D. Belfonte
Reviewed in the United States on December 6, 2018
I would like a replacement that has a down light and an uplight not just one light but otherwise very good
thom's brain
Reviewed in the United States on April 5, 2018
Worked great to get our Hampton Bay fan working again. The fan had gotten so it would respond to fewer and fewer remote commands until it finally stopped responding altogether. Replaced the remote and it worked a little better but then stopped again, so replaced the receiver with this and back in business. All the wires are labeled and it comes with wire nuts. These receivers are located in the ceiling mount of the fan, not on the motor side. No need to dismount the fan for replacement. Took me about 10 minutes to figure it all out and finish the job, including getting out the ladder.
dew
Reviewed in the United States on September 2, 2017
Easy install. My Harbor Breeze fan is once again obeying my commands.
Sean Wilkerson
Reviewed in the United States on August 29, 2017
We had 2 ceiling fans in one room and 1 stopped working. After doing some mild evaluation I realized it was possibly the receiver. This unit came well-rated on Amazon and it seemed like it was similar to my current unit.The installation took just about 20 min, it was fairly easy and seemed like almost an identical replacement to the original factory unit. I am thrilled not to have to replace the entire ceiling fan.It looks just like the picture. My only problem was, it didn't have a door/cover to the dipswitch opening. The part I was replacing did have a little rubber square designed to cover the dipswitch opening, so I used that on this new Anderic unit.
Recommended Products