Your cart is empty.
Your cart is empty.The Yonico panel raiser router bit 12142 will make raised panels for cabinet doors in an elegant ogee & bead design. Use the panel raiser in conjunction with any one of our rail and stile router bits. Two flute carbide cutters & 1/2" Shank.
Anthony
Reviewed in the United States on September 25, 2020
This bit is all it was advertised as. Strong good purchase. Strongly recommend this purchase.
scott smith
Reviewed in the United States on December 3, 2020
Used alot on pine drawer fronts and cabinet doors, stayed sharp so far and it's done alot. Make sure you run it at the correct speed, I slowed it way down on my router.
michael casavant
Reviewed in Canada on March 31, 2019
satisfait du produit
Scott C. Voth
Reviewed in the United States on January 25, 2019
I know that several reviews stated that this large cutter vibrated badly. I did not experience this. I ran it with a 3.5 hp router in a cast iron router table at full speed and it did not vibrate. It did sound like a jet engine though so use hearing protection. It cut cleanly however with such a large cutter when making several passes to remove more material, it is hard to maintain a steady 90 degree angle on your stock and you get a wiggle in the cut every time it moves even a little. Maybe doing everything in one cut is the better way to go but I was afraid I get some chip out if i did. Overall, it did want I wanted it to do and was a good value.
Recommended Products
$27.95
$ 14 .99 $14.99
$171.06
$ 82 .99 $82.99
$70.30
$ 27 .99 $27.99
$66.99
$ 29 .99 $29.99