Your cart is empty.
Your cart is empty. Features:
Allows forming and bending of the thermocouple,no need to worry about the risk of cracking
Can compatible with TM902C/TES1310 Meter to use
Operating Temperature: -50-700°C
Probe Material: metal
Probe Diameter: 0.6mm /0.023 inch
Probe Length: 8.33mm /0.328 inch
Cable Length: 3 meter
Cable Internal Insulation: Fiberglass
Connector: K Type Mini-Connector
Package includes:
5pcs 3 meter K Type Thermocouple cable
Steve
Reviewed in the United States on February 1, 2025
nice set of thermocouples. Good for many high temperature locations. Good buy.
BF
Reviewed in the United States on January 25, 2025
These are kind of a commodity in the temperature measuring world, so not looking for anything special. But they look and perform as expected, and are cheap.
Grandpa
Reviewed in the United States on December 22, 2024
After a few uses the outer wrap on the leads wears and tears such that the insulation on the two sensor wires is exposed. This happens in particular at the "corners" where the leads take 180 degree turns to fold them up when packaged. These "corners" are persistent, it appears the sensor wires have "memory". The corners also cause the leads to tangle with each other when setting up and stowing. More durable material should be used for the outer jacket. Hopefully the insulation on the sensor wires is more durable.Otherwise, the leads work fine so far, and readings appear accurate although no attempt was made to check calibration since accuracy to a degree or two is sufficient for my applications.
Andrew
Reviewed in the United States on June 25, 2023
The bead on these are smaller then a pen tip. As a result there is a large amount of fluctuation +- 15 C in a mixing liquid with heating application. I had to get creative with the averaging technique but the end data was great
Leslie McBride
Reviewed in the United States on February 14, 2022
These give excellent results with the max31856 with below 1C deviation from an rtd probe. I removed the connectors which are not compatible with the screw tabs that come with the module. With calibration this looks like it will be very accurate. These fit inside of a 3mm id thermowell. These are double sheathed with fiberglass. I have not tested the upper limits.
Joules P. Second
Reviewed in the United States on January 23, 2021
The media could not be loaded.
Sam Allen
Reviewed in the United States on March 4, 2020
I purchased a pack of these and as soon as I installed them, 1 of them was calibrated in reverse (reading went down as temperature went up) and the other would lose the reading if the connector was moved in any way. The connectors are also very large and I could only fit 4 of them in my 8-channel logger.
Nirup K.
Reviewed in the United States on February 25, 2020
I was not sure when buying if these thermocouples will work at all since they were so cheap but they are well made. All of them work and in defined accuracy. My only complaint is that the outer cover is made of fiber glass which is annoying to work with since the tiny fiberglass gets all over you and start to itch.
Recommended Products
