Your cart is empty.
Your cart is empty.Product Description
Brass Package Included
- 1* Battery switch
- 4*Mounting bolt and screw
- Removable side pads & Button cover
1-2-Both-Off Battery Disconnect Switch
12-48V Battery Cut Off Switch
Spurtar DC 12V - 48V 1-2-Both-Off master off switch for cars, marine boats, RVs, campers, travel trailers, trucks, ATVs, UTVs, battery banks, and other devices.
Specially design for 2 batteries, can switch to battery 1 / battery 2 separately or both on and off together. Eliminate any power from the battery when vehicle or boat is not in use, disconnect the battery safely.
- ABS plastic housing, durable made for safety use.
- Equipped with 4 sets of bolts: 1-2-Both-Off 4 positions.
- Rear cover insulates terminals against any short of circuits.
- Used to isolate and secure the electrical system, can stand alone or be locked together with other switch.
Dual Battery Disconnect Switch
Design for 2 batteries and equipped with 4 sets of bolts: 1-2-Both-Off 4 positions to use for DC 12-48V systems to isolate and secure the electrical system.
Safe Locking System
Spurtar battery switch can stand alone or be locked together with other switch, protecting the power supply for minimizing battery loss and preventing electric leakage effectively.
Heavy Duty Cut Off Switch
Battery selector switch is made of premium ABS plastic outer shell, 4 removable side plates, durable and dependable for safety use, rear cover insulates terminals against any short circuit.
Widely Applcation
This battery ssolator Switch is widely used for Car, Marine, Boat, RV, Camper, Travel Trailer, Truck, ATV, UTV, Battery banks and other 12-48V Devices.
Customer
Reviewed in the United States on February 24, 2025
Works great
Duke78602
Reviewed in the United States on January 30, 2025
Use this battery disconnect on our boat when not in use.makes it nice, not to have to worry about the battery being drained while sitting up
lawrence crocker
Reviewed in the United States on September 22, 2024
Great product fast shipping
E. D.
Reviewed in the United States on August 7, 2024
It works correctly and seems to well build.
Arlie Lawrence
Reviewed in the United States on August 21, 2024
Solar battery set up, as a sailor have used same item on boat. Allows isolation and switching of battery banks!!!!! Works great and well made
Captain Poet
Reviewed in the United States on June 17, 2024
This switch is smaller than the Perko units but works exactly the same. Handles the two boat batteries without a problem. The price is good too. I am ordering another one for my tow vehicle. We got out fishing for a week at a time. It's great to be able to shut off the batteries.
Grubar30
Reviewed in Australia on February 15, 2024
All cons:- the On Off writing is tiny.- this device won't work with 2/0 AWG lugs and higher as the cutouts don't accommodate. I would say you may even have trouble with 1/0 AWG lugs. No way could i get the 2/0 lugs to fit and i tried each of the 4 cutouts. How pathetic is that???I have ordered other similar switches from Amazon and they accommodate the LUG size above ok.
Scott
Reviewed in the United States on November 30, 2024
I built a dual battery system for my remote travel vehicle and used this switch to tie it all in, along with a smart controller. I vary which battery I use and then will turn them all off if I'm in a spot where I feel it's needed. This switch is the base of that system and has so far given me no problems.
Paul
Reviewed in Australia on January 31, 2024
Very good quality for price and seems well made this replaced a more well known brand that was faulty and leaking current. This did the job and recommended
Robert Fleshman
Reviewed in the United States on April 17, 2023
This is the third switch I have purchased. Each for a different application. They work very well, allow you to operate one battery or the other, or both if you desire. Most importantly you can disconnect your batteries when not in use.My only complaint is the same with each one I have installed. Due to their compact nature connecting the wires is difficult due to the tight space. If you are using good size cables and connectors you will need to bend the connectors at a sharp angle to get them to fit. This can make it difficult to tighten the nuts on the switch post.
Recommended Products