Your cart is empty.
Your cart is empty.Product Description
-
For dealing Acrylic
O Flute Router Bits
Compared to other spiral router bits,O flute router bits dealings are cleaner and deeper.
-
For dealing Aluminum
O Flute Router Bits
Low melting point material, Single Flute Cutting End Mill is a good option.
-
For dealing Copper
O Flute Router Bits
Heat is dispersed more easily with the O flute bit,it stops weld back.
-
For dealing Wood
O Flute Router Bits
Chips up or down varies in spiral direction, larger flute valley allows bigger chips.
Morosan ioan.
Reviewed in Canada on February 4, 2025
They are good stuf
Customer
Reviewed in Canada on January 28, 2025
1/4 x 1 O flute uncoated has performed well during the initial couple hours of cutting in 6061 Aluminum.Speed and feeds on vendor site work good.I will buy again.
Larry
Reviewed in Canada on January 26, 2025
I use them on a 6X10' cnc router with a perske 7.5hp spindle and they seem to perform as well as anything I've tried.
GoBlue9123
Reviewed in the United States on December 3, 2024
Used on polycarbonate and 6061 aluminum- nice clean cuts
Jon Hoskinson
Reviewed in the United States on January 30, 2024
This endmill has the good shape that I like and I have bought them before and they worked well. However this batch melted down quick on the exact same feeds and speeds. I may have bought a bad batch but will not buy again.
shane barbur
Reviewed in the United States on August 2, 2023
THEY HAVE A DEGREE ANGLED CUT, BUYER BEWAREThe router bits will cut material at small degree angle sloping upwards.
Customer
Reviewed in Canada on June 7, 2023
Using this for awhile, still cuts! I love speetool bits for cnc
K. Williams
Reviewed in the United States on April 28, 2023
I used this to cut slots in an aluminum extrusion. It worked much better than I'd expected.
Mike M
Reviewed in the United States on September 5, 2022
Only 1 cut so far but almost no cleanup after first cut
Custom Contracting
Reviewed in Canada on May 25, 2022
Got what I asked for , using for my cnc package bit strange on my first ordered showed all end mill bits but it was mixed bits but it’s what I wanted
todd heath
Reviewed in the United States on October 2, 2022
I run lots of different bits and this brand is one I can for the most part count on as being a decent bit. Not the best but not the worst brand. I have had pretty good luck with the brand but have had a few that didn’t last very long or just not up for the job. They are not super expensive but not cheap ether. With so many choices I can usually count on them. If i am doing a big job or something that is really precise i don’t use them I will use a brand I trust a bit more. Not saying this is a bad brand.
Alexander
Reviewed in the United States on April 9, 2022
Works with aluminum good
Jeff T.
Reviewed in the United States on January 27, 2021
I ran this faster and deeper than I thought I would be able to. Ramp into your material, and use a nice cutting/cooling fluid, and go for it. Nice bit, really.
Recommended Products