Your cart is empty.
Your cart is empty.
The Type R632A is an Underwriters Laboratories (UL) listed regulator designed for Two-Stage LP-Gas systems. The unit is designed to reduce the tank pressure through an integral two-stage system to 11 inches w.c. / 27.4 mbar. The first-stage screened drip-lip vent is oriented downward and the second-stage vent is oriented over the outlet as standard.
!!! WARNING !!! Failure to follow these instructions or to properly install and maintain this equipment could result in an explosion and/or fire causing property damage and personal injury or death. Fisher equipment must be installed, operated and maintained in accordance with Federal, state and local codes and Fisher instructions. The installation in most States must also comply with NFPA no. 54 and 58 standards. Only Personnel trained in the proper procedures, codes, standards and regulations of the LP-gas industry should install and service this equipment.
BUYER AGREES THAT RESPONSIBILITY FOR PROPER SELECTION, INSTALLATION, USE AND MAINTENANCE OF ANY PRODUCT REMAINS SOLELY WITH THE PURCHASER AND END-USER. BUYER AGREES TO COMPLY WITH THE ABOVE WARNING AND ALL INSTRUCTION MANUALS, BULLETINS AND INSTALLATION GUIDES ASSOCIATED WITH THIS PRODUCT.
Nelson torres Vargas
Reviewed in the United States on February 23, 2025
I bought this item and now I can't install it on my trailer because the thread on the bronze colored side is not 5/8 and it's not even 1/2
nick downing
Reviewed in the United States on July 15, 2024
Installed on a 250gal tank and works perfectly for my built in jacuzzi
AM
Reviewed in the United States on May 2, 2024
Awesome. Swapped this in for the old leaky one. Perfect. Happy
Customer
Reviewed in the United States on January 28, 2024
It took me 3 trys to get the right replacement valve. Not Emerson Fishers fault, error on my part. My LP heater is now working great.
Janet Fisher
Reviewed in the United States on April 3, 2024
Good quality, good price, prompt delivery
Customer
Reviewed in the United States on December 8, 2023
It’s running 2 90000 btu fryers and a 120000 griddle. And a 200000 btu water heater. No volume problems. Supplied by 2 120 gallon tanks. Does well when the temps hit 25 deg.
Gabby_Jim_41
Reviewed in the United States on July 2, 2020
Bought this to replace the junkie little thing that came on my RV and would not work in extreme cold (say, minus 20f). It was easy to install (as soon as I realized the input was a standard female P.O.L DUH!) I used a natural gas / propane hook up kit from a localhard ware store (85,000 BTU rated, 24" model CCSO, 38 I.D. flexible stainless steel) to connect the regulator to the propane inlet (see it under the regulator in the picture). I first fastened the regulator to a piece of sheet metal salvaged from an old microwave oven, painted it flat black with high-temp paint, then screwed it to the rock shield on the front of the RV. (see the picture - used a LOT of screws to get good contact.) This provided a MASSIVE (reverse) heat sink for the regulator - I am confident this regulator will work even at minus 35F - (Propane becomes a liquid near minus 40F, I believe that NO regulator will work at that temperature without an outside heat source. If it gets THAT cold, I'll shine a heat lamp on the rock shield - as I had to do with the junkie that came with the RV.)
Recommended Products
$41.82
$ 22 .99 $22.99
$100.00
$ 41 .99 $41.99
$585.95
$ 99 .00 $99.00