Your cart is empty.
Your cart is empty.David
Reviewed in the United States on February 19, 2025
Got this for a genmon project to store the pi and it fits great. Good looking box.
Tgroup
Reviewed in the United States on February 11, 2025
Well made waterproof box. Set up the sauna controller in it. Works great
dankrill
Reviewed in the United States on January 17, 2025
very strong material, the bread board mounting mesh fixed to the rear interior is perfect for mounting components. the rubber gasket seal also works great at keeping your hardware safe, would deff buy again!
Rolidnot
Reviewed in the United States on July 26, 2024
The media could not be loaded.
Nissim
Reviewed in the United States on February 5, 2024
Great item and amazing customer service! I'm using it for my CCTV and LED strip setup, it works great and even when I had a tiny problem, customer service was there to help me out. You can count on QILIPSU for your professional configurations, it's not just a store on Amazon, it's a top quality brand with REAL warranty.
Dr. Dan
Reviewed in the United States on December 16, 2024
I have used these to make water tight electrical connections, hold relays and contactors, and mount switches on. High quality. Love the screw down board.Just remember to order grommets to seal wire entries.
Jason
Reviewed in the United States on November 29, 2024
Such a great sealed box perfect for outdoor and excellent price!
John KaBang
Reviewed in the United States on April 24, 2024
The box I got had a few slight surface blemishes in the clear cover. Perhaps I can polish them out. But the time and date stamp molded into the cover was disappointing. I would have preferred that to be done on the back side of the bottom. The plastic was easy to drill and so far seems to be holding up just fine. Over all the box is fairly rigid for it's size. And since my project will be used strictly indoors, I'll remove the cover gasket to make it easier to latch closed. It did come with a hardware package to fasten the internal building plate. The plate was one of the nice features I like. I can assemble 99% of my project on that, then just install it in the box and I'm nearly done. I just wish the hole pattern in the building plate was either on 0.1 inch spacing or better yet nonexistent. If I buy another one with that building plate, I'll just replace it with a solid piece of G10 instead.
Recommended Products