Your cart is empty.
Your cart is empty.This socket is the only way to remove the special nut and to torque it down to the specified 157 lb-ft. It is 1/2" drive and can be used with a breaker bar, impact gun and torque wrench. This tool is nickel plated so it will never rust or corrode. It comes with a 100% satisfaction guarantee and a lifetime warranty. This tool is 100% Made in the USA.
RJ Burrage
Reviewed in the United States on February 13, 2025
A hard to find necessity for these trackicks
Marcelo
Reviewed in the United States on January 26, 2025
Nicely made with tight tolerances, I could loose and tighten the nut to specifications (216Nm) with no issues on my Suzuki Grand Vitara (SQ416)
Pedro Lopez
Reviewed in the United States on September 29, 2024
This will work on a 2004 Chevy Tracker
Customer
Reviewed in the United States on September 18, 2024
Great product worked great
rick gilchrist
Reviewed in the United States on September 17, 2024
A must have and is made a heck of alot better than some of the cheaper ones. This thing will last.
Joe H.
Reviewed in the United States on October 6, 2024
Very heavy duty and worked fine.Had to use a cheater pipe to break the nut loose.
NOTETAKER
Reviewed in the United States on December 8, 2023
Product arrived fast and in good condition, product works but 1/2 inch stud on torque wrench didn’t seat fully in socket which created a problem trying to torque socket to 158 ft-lbs, other than that product works, would have to rework socket to get it to work.
Alex
Reviewed in the United States on February 3, 2020
Worked well but pins could be stronger
Recommended Products
