Your cart is empty.
Your cart is empty.M11 x 1.5 x 130mm HSS reduced long shank right hand thread tap. Nominal diameter: M11 Thread Pitch: 1.5mm Overall length: 130mm Reduced shank allows tap to make a long thread in a through hole.
Aki.sas
Reviewed in Japan on August 25, 2024
エクシーガクロスオーバー7のリアメンバーボルト車体側メネジを舐めてしまい途方にくれてましたが、無事復活できました。似た製品で160mmは短くどんつきまでは届きませんでしたのでこちらの製品が正解でした。
Robert H Parnell Jr
Reviewed in the United States on June 21, 2024
It did what I needed it to do
Chelvin
Reviewed in the United States on June 18, 2024
good tap chase it's as good as the high dollar ones long enough to reach down into headbolt threads 5.7 hemi
Douglas A. Ellmore, Sr.
Reviewed in the United States on December 29, 2024
Thread cutter snapped in pre-tapped hole while testing. Can’t even remove the broken head because it is 3” deep.
A.P
Reviewed in the United States on December 16, 2024
Works great and was Great quality
George H
Reviewed in the United States on November 3, 2024
I ordered the wrong size, but ended up using it for another job... worked great
Ole Ole
Reviewed in Canada on June 10, 2023
I damaged engine block threads by over tightening the head bolt during its installation. With that tap I didn’t have to remove the head again, I simply found same bolt 1mm larger in diameter and made a new thread. Engine is happy. Much cheaper solution than what they charge for special kits.
タケ
Reviewed in Japan on May 1, 2023
The media could not be loaded.
Claudia S.
Reviewed in the United States on October 5, 2023
Got this tap for a Ford engine block we are building, and I need to chase the threads for the head's bolts. The longer length is required, and this works great.
Shawn M.
Reviewed in the United States on June 8, 2021
Manufactured very well....smooth grind on the flutes... accurate threading. Well worth the shipping period!
Jk308GTB
Reviewed in the United States on January 3, 2021
This tap worked perfectly
Recommended Products
