Your cart is empty.
Your cart is empty.3.9 out of 5 stars
- #267,642 in Patio, Lawn & Garden (See Top 100 in Patio, Lawn & Garden)
- #45 in Pond De-Icer
Install Instructions Unplug the Unit From the Power Source Loosen and Remove the Existing Power Cord Take Replacement Power Cord and Run Through the 2-1/2″ Water Intake Hole at the Bottom of the Shroud Apply a Small Pea-Sized Amount of Dielectric Grease to Power Cord Connector Line Up the Pins and Holes From the Power Cord and Connector on the End Bell, and Then Twist it on Make Sure to Hand Tighten Only – Do Not Over Tighten – Do Not Use Tools In Order to Prevent the Power Cord from Hitting the Propeller, Pull Out Additional Slack Through the 2 1/2″ Water Intake Hole and Secure with Clip and Screw One Additional measure you can take is to secure the power cord to a bracket with a zip tie and then secure with the clip and screw on the shroud. Spin the propeller by hand after you complete the install to make sure the propeller does not hit the cord.
Jim Harris
Reviewed in the United States on October 24, 2024
Exact duplicate of OEM.Easy to install
Recommended Products
$51.99
$ 27 .99 $27.99
$59.97
$ 30 .99 $30.99