Shopping Cart

Your cart is empty.

Your cart is empty.

Front Track Bar Bolt and Flag Nut Retainer-for Jeep Wrangler TJ 97-06 Jeep Cherokee XJ 84-01 Jeep Grand Cherokee ZJ 93-98 Replaces 6504449

4.9 (7) Write Review
Free shipping on orders over $29.99

$12.45

$ 5 .99 $5.99

In Stock
  • Item Type: Track Bar Bolt,Flag Nut Retainer
  • Color: Yellow zinc
  • Manufacturer Part Number: 6504449
  • Flag nut replaces Mopar part number 6504449,Metric Class 10.9 (metric equivalent to grade 8) yellow zinc plated flange bolt and flag nut retainer for attaching the front track bar to the axle on for 97-06 Jeep Wrangler TJ's, 84-01 Jeep Cherokee XJ's and 93-98 Jeep Grand Cherokee ZJ's.
  • Placement on Vehicle: Front. To prevent unreliable swinging, the TRAC rod is an important hardware component, and this bolt is a critical component. It is manufactured based on raw vehicle data
  • Items Included: flag nut, nuts, Bolts


Condition: New
OE/OEM Part Number: 6504449
Placement on Vehicle: Front
Manufacturer Part Number: 6504449
Color: Yellow zinc
Item Type: Track Bar
Items Included: flag nut, nuts, Bolts
Metric Class 10.9 (metric equivalent to grade 8) yellow zinc plated flange bolt and flag nut retainer for attaching the front track bar to the axle on for 97-06 Jeep Wrangler TJ's, 84-01 Jeep Cherokee XJ's and 93-98 Jeep Grand Cherokee ZJ's.
Flag nut replaces Mopar part number 6504449


Riley Grunow
Reviewed in the United States on March 5, 2025
Will it work? Sure absolutely. The bolt will snap before you tighten it fully, so be prepared for that. I just used the flag nut and fully welded it instead of brazed it on.I would’ve been better off making my own flag nut to be honest.
Mike R
Reviewed in Canada on September 14, 2024
It broke in half while torquing to spec. Unsafe part that could cause an accident if it broke while driving. Get a quality grade 8 bolt, do not trust this junk.
Chris
Reviewed in the United States on September 10, 2024
Replaced stock bolt and nut with this one after installing a new track bar. It stayed tight for about a week. While tightening down with a 1/2 drive ratchet it snapped in half. Save yourself the time and go to a hardware store and buy true grade 8 hardware.
PC
Reviewed in the United States on May 26, 2024
I bought this to replace a rusted and stripped out factory flag nut. Only reason it gets 4 stars is the minimal tack welds on the flag nut section. I can see this breaking loose if an impact is used making it useless. Be careful if using an impact.
doug
Reviewed in the United States on February 2, 2024
Made it so much easier to put back together
Dan kechter
Reviewed in the United States on December 23, 2024
Was the perfect replacement for fixing the one I broke
Kindle Customer
Reviewed in Canada on November 6, 2024
The nut snapped off the plate when installing, completely useless