Your cart is empty.
Your cart is empty.Product Description
ISO Certification
- SO9001 Certification Safety Performance,
- Good acid resistance, Alkaline resistance,
- High temperature resistance, and a variety of grease resistance
Product Specification
- Wire length 12 inch
- Max Contact Rating :10W; Max Switching Voltage :100V AC/DC;
- Max Switching Current :0.5A; Max Load Current:1.0A;
- Max Contact Resistance:100M¦¸
J. K. Grady
Reviewed in the United States on February 25, 2025
the ratings are not right electrically for a reed switch .One cannot switch 120 v at 100 mA .To get it to live use 5-12 vdc with a relay , put a diode 1n4007 across the relay coil such that bar of diode ( stripe ) is toward the positive end of coil when on . Dont get it wrong you will hurt switch . When it shuts off ( opens) the diode suppresses the spark inside the switch . Will live forever . All the complaints if failures on here are due to overloading switch due to incorrect info / use in 120 v reaky or loads
Heike O
Reviewed in the United States on June 4, 2024
I use it to stop the pump when the water towner is full in my off grid garden. I have it run through a relay to start and stop the pump. Works very well.
Customer
Reviewed in the United States on November 30, 2024
Use these to prevent a cooling reservoir from overfilling for a hobby. They've worked reliably for 3+ years and control the water pump on a good hysteresis loop that allows for good on/off cycling.
Charles Popelka
Reviewed in the United States on August 13, 2023
Needed a new float for an existing switch . Manufacturer wanted $173.46 for a whole new switch and wouldn't sell me just the float ! I don't know if this unit even works , but the float did and now i have a spare too . Ha Ha Ha .
Janelle
Reviewed in the United States on June 12, 2023
would be nice to have an easier adapter at the end to find an attachment for. An easy to use switch.
LB
Reviewed in the United States on December 16, 2022
Sorry, but People can not read directions.It works IN either NO or NC. Just Flip FloatYes, It can also be mounted from TOP or Bottom.IF IT FAILS its because you are trying to pull too much power through it.It is designed to switch a relay or something that pulls lower than 20Va.This thing is currently operating the water level in a Industrial Hot water Parts Washing machine. Water temps are 180 F. It is constanly having to fill. BUT as the directions explain, you need to use a relay to drive the water solenoid. I found one solenoid that is used for Ice Makers that is lower than 20 Va.
Customer
Reviewed in the United States on April 24, 2020
I Purchased two And one only last about two months part time use other one seems to be fine
Tim
Reviewed in the United States on February 2, 2019
This lasted about 1 month in use before switch failed in closed position continuously. No movment in either direction of float would stop my alarm from sounding. Absolute cheap junk
Recommended Products