Shopping Cart

Your cart is empty.

Your cart is empty.

D1CS-D Capacitive Water Tank Level Sensor Come with 500mm Cable(Pack of 3)

Free shipping on orders over $29.99

$8.00

$ 3 .99 $3.99

In Stock
  • They have no moving parts and are ideal for point level sensing of water.
  • Installation is simple outside the tank.
  • Notice:The max tank thickness is suggested 5mm and the tank material is placstic.The liquid should be clean water only.Metal tank is not proper.
  • They are suitable for high, low or intermediate level detection in practically any tank, large or small.
  • 1 YEARS WARRANTY:EPTTECH has provided liquid detection solution for over 20 years.1 years gurranty for longterm service.



Product Description

Product Dimension

1

Unit:mm

Length:380±10mm

2

Waterproofing standard IP64

size

Installation

installation

Screw fixation

A:Water tank thickness

installation

Snap-on fixation

installation

Liquid level is higher than 1: there is water.

Liquid level below 2: no water.

Electrical Specification

Working Voltage 5V
Output Voltage in Water 0V
Output Voltage in Air 5V
Operating Temperature -20~40℃
Recommended Application Circuit

Recommended Application Circuit

1)Criterion of detecting liquid level depends on the structure and thickness of clients' water tank;

2)When detected liquid, the sensor will output <0.1V low voltage;

3)When detected no liquid, the sensor will output >VCC-0.1V high voltage;

Notice:

4)The sensor can't be used near metal.

5)The sensor cannot be placed in a humid environment.

application

Application

Simply locate the sensor to outside the liquid container (low temp) for detection. Easy assembly

application

1


RSTJA
Reviewed in the United States on February 12, 2024
The data sheet that came with these sensors was terrible, so I made my own for others to use. I tested these sensors to measure: Current draw, sensing distance, and general operability. They sense water level well (doesn't matter if the liquid is conductive or not, I did the experiment and nothing changes). You must put the smooth side towards the liquid to be sensed, or they won't work. This is odd, as the mounting flanges seem backwards at first glance. You will see for yourself. I initially thought they didn't work. There are errors in the data sheet supplied by the manufacturer, but my numbers are correct for the three units I tested. Overall, not a bad deal especially for something so cheap. I wouldn't use it for Grandma's meds, but that goes without saying...
JR
Reviewed in the United States on November 30, 2024
They are nice and compact. Unfortunately since you can't calibrate these, you might find that they come on / remain off when they shouldn't, and this behavior can change day to day. I ended up having to replace them with a homemade one so I'd have more control.
Richard I.
Reviewed in the United States on May 4, 2023
Los use para controlar una válvula solenoide de entrada de agua a un tanque de 300l de apartamento, y para detectar tanque vacío y apagar la bomba de agua. Debido a que funcionan con 5V , use un circuito de 2 relés que venden en Amazon para Arduino y trabajan bien, a través de la pared del tanque de 4mm de espesor.