Your cart is empty.
Your cart is empty.Product Description
Teresa Letteer
Reviewed in the United States on January 27, 2025
Husband loves it
Clayton
Reviewed in the United States on June 17, 2024
Worked perfectly for a project where I needed a large tap.
GB
Reviewed in the United States on June 12, 2024
seems to work as expected
Claudia V.
Reviewed in the United States on December 4, 2024
Bought this to for the purpose of cleaning out a hole left dirty by an old BMW (1999 528i) water pipe (plastic with o ring ends). Worked perfectly for that. Seems like quality tool that would work as it should for anything.
Geno
Reviewed in the United States on December 31, 2024
just what i needed.
F. S.
Reviewed in the United States on October 27, 2024
I bough this to thread a 1/4” piece of Stainless Steel. Did a great job.
Very picky Customer
Reviewed in Canada on June 28, 2023
Dings, nicks and burrs covering two of the flutes of the tap straight out of packaging. Grease and grit in multiple threads. Cutting edge feels very dull and rounded.
Customer
Reviewed in the United States on October 25, 2023
I have a Jet 1221VS, and this tap is the perfect size to thread a 7/8 drilled hole to fit my 1" 8 TPI headstock on the lathe. I made a few sanding drums, and I'm looking forward to making more jigs and fixtures for future turning. This tap made clean threads, and I did not have any issues. It should last forever since I'm only using it in hardwood.
Michael J Tucker
Reviewed in Canada on January 19, 2022
it works good cut s good good price
Dan Leblanc
Reviewed in Canada on October 20, 2020
I liked the end results. I do not have a thread micrometer so how accurate is it, do not know. It thread fine on to the threads my lathe made.
John P.
Reviewed in Canada on November 3, 2019
Tap was as expected
Big Mike
Reviewed in Canada on October 7, 2019
Good quality. The one I got was made in Japan. Sharp.
JD Combs
Reviewed in the United States on March 14, 2017
Worked very well for my purposes. I used it to cut threads into UHMW plastic material so I can't comment on how it would do in metal. If I had been intending to use it to thread metal I would have opted for a HSS version instead of high carbon steel. HSS is more typical of bits used to cut metal especially steels. Visually it seems of very high quality with well defined and sharp looking cutting edges.
Recommended Products
$15.47
$ 6 .99 $6.99