Your cart is empty.
Your cart is empty.5/8" - 24 right hand tap and die set. High speed steel tap ground thread to cut thread in one go from zero to full thread. Round die outside diameter 38mm.
Cornel Cirica
Reviewed in Canada on April 23, 2023
filet!
Serg
Reviewed in Canada on March 13, 2021
a
Andreas Kothke
Reviewed in Canada on March 10, 2021
It's works .
Wade
Reviewed in the United States on January 19, 2020
I bought the 1/2x28 set earlier to make muzzle devices and was pleased so I purchased this set to do some 5/8x 24 pieces. I have a lathe so tapping isn't too big of a deal but I can see how it might be trying these fine thread taps by hand in something supported say in a vice without a way to center the tap or die. I also purchased a chucking reamer the correct size for the hole for tapping so it would be exact not over or under size. I always drill under size then bore the holes with a small boring bar and leave a small percentage for the reamer for the clean up. Muzzle devices need to be concentric and not off center for obvious reasons and barrel threading should always be concentric to the bore. Cutting new threads especially on a barrel by hand could turn out bad. I would never do it.
Tim G
Reviewed in Canada on July 19, 2019
This will work fine
Customer
Reviewed in Canada on October 13, 2018
Good tools
GLG
Reviewed in the United States on April 14, 2018
I used the die to make some bushings to go from a barrel that was threaded 1/2 28 TPI to 5/8 24TPI so I could thread a .308 suppressor on. It doesn't leave the smoothest thread ever but they work.
Rob
Reviewed in the United States on September 7, 2017
Worked very well chasing threads on a 6.5 Creedmoor barrel. Good thing to keep around if you're shooting threaded 30cal+ barrels.
James J. Roscoe
Reviewed in the United States on August 1, 2017
Works the way it's designed.
Customer
Reviewed in the United States on February 22, 2017
Tap worked great the die in my opinion was tight but they got the job done I would look for one with an adjustment screw
DJENSEN
Reviewed in the United States on February 16, 2016
Great tap and die set. Just used mine for the seventh cut yesterday. Get a 9/16 bit to pre tap and you will be in business. Have cut all types of aluminum and 316ss with no problems. Will purchase again when mine does decide to wear out.
R'Sonal
Reviewed in the United States on July 16, 2015
Needed to fix my Mosin Nagant threads and suppressor after I had it fall while taking it off trying to put the muzzle brake back on. Ot damaged both the threads on the muzzle ans suppressor. Shipping was fast and this is the best deal I've found so far.
IBpackin247
Reviewed in the United States on October 29, 2013
as taps and dies sold ubder US brand names. I noticed that most US brands are made in China anyway, so I decided to go straight to the source and save money. While I don't know if it will hold up to as much stress as a major brand set will, it did perform well for me. I used the die on a gun barrel and on a steel pipe, and used the tap on a stainless steel bushing.
Recommended Products
