Your cart is empty.
Your cart is empty.hoovinator
Reviewed in the United States on May 30, 2023
In the picture, the one on the right is the original that I accidentally bent and ordered a replacement part. The one on the left, along with the packaging, is what arrived. It does install into the tool but it's too short to actually install a plusnut. The description says this is compatible with the 1450.
David LeVine
Reviewed in the United States on December 2, 2023
In most rivet nut sets, the #10-24 mandrel is included. In rack mounted equipment the screws are #10-32. They don't interchange.I do some rack mounted hardware and this inexpensive addition solves the issue for me.
Simon Crisp
Reviewed in the United States on September 30, 2021
Many reviewers have had the same issue as me; in various riveter nut sets and mandrels purchased separately, the one stamped 10-32 is actually a 10-24. So in many sets you end up with two of 10-24, one which is incorrectly stamped 10-32. This item solves the problem for $4 - you don't need a top nut as the one from the wrongly marked 10-32 is the correct size.
Gerry Halberg
Reviewed in the United States on September 2, 2021
It took 5 tries, but I finally got the correctly threaded mandrel. I can't figure out why this was so difficult.They kept sending me mandrels that were threaded 10-24 ( even though they were marked 10-32). Iwas ready to give up trying, but thankfully I gave it one last try and they got it corrected.
katie hicks
Reviewed in the United States on November 2, 2021
mine came out as a 10-24, not 10-32 like the package said
jerry brown
Reviewed in the United States on April 19, 2021
WAS BENT .I think it will work since i straightened it out. JUNK JUNK
Recommended Products
