Your cart is empty.
Your cart is empty.Use a Two-Flute bit where fine finish is paramount. Two flutes balance the bit, eliminating vibration that degrades the cut finish. Two cuts per revolution yield a smooth surface, but feed rate is slightly reduced, #45223, diameter (D): 15/32, cutting Height (B): 3/4, shank (D): 1 /4, overall length (L): 2, plywood thickness: 1/2 minus 1/32, flutes: 2, 45223 carbide Tipped Undersized plywood dado plunge 15/32 dia x 3/4 x 1/4 inch Shank for plywood thickness 1/2 minus 1/32
Karaokemaniac
Reviewed in the United States on May 24, 2024
Bit broke after a couple months of light use.Cutting 6mm deep slots in plywood and maple. Kept feed rate low and did not feel like I was forcing it.
Mack Levine
Reviewed in the United States on January 27, 2023
I’m not sure where the “plunge” descriptor comes into play because there does not appear to be a cutting element that would remove material over the center of the shank. I tried plunging with it and it just burns the wood in the center of the cut into a button shape like other straight bits would.
Rval
Reviewed in the United States on February 3, 2021
Bit is sharp and makes a clean 15/64" cut.
Aaron
Reviewed in Canada on June 5, 2020
This router bit made 3 two foot passes through MDF and snapped into 2 pieces. With shipping this little bit cost a lot of money and took a long time to reach me. Not happy.
bunjes
Reviewed in the United States on July 31, 2019
This is so handy for making shelving with "3/4”” plywood. A perfect fit with nearly perfect edges every time.
Kim
Reviewed in the United States on June 7, 2017
Snapped in half on the 3rd cut.
Recommended Products
$25.35
$ 11 .99 $11.99