Your cart is empty.
Your cart is empty.Product Description
ACTOOL HSS Annular Cutter for Magnetic Drills
ACTOOL HSS annular cutter deliver excellent efficiency, durability and precision
- ACTOOL HSS annular cutter, with unique cutting edge geometry provide efficient cutting, fast feed rate,less vibration,smooth hole surface and long tool life,the effective of drilling is much better and quicker than the common drills.
- ACTOOL HSS annular cutter has the advantage of being durable, super tough and longer tool life.
- ACTOOL HSS annular cutter with weldon shank can be used with most major magnetic drills, can also be used with machine tools such as mills and large drill presses with tool holders.
- ACTOOL HSS annular cutter can be widely used in drilling steel, copper, aluminum, stainless steel and plastic, in either plate or pipe form.
Operation Notice
- Wear protective equipment during operation
- Ensure the drill and metal sheet are secured
- Set appropriate RPM and feed rate
- Use with coolant for longer tool life
PT
Reviewed in the United States on April 8, 2024
This isn't a great annular cutter. Had a hard time forming clear cut metal chips/spirals. After a few holes it was becoming dull. I would stay away.
Yosmil
Reviewed in the United States on April 24, 2024
The media could not be loaded.
Max Barrington
Reviewed in the United States on August 3, 2021
I have used this for cutting 12 holes in 1/2 steel plate. No issues. Still as sharp as when I started. The first time I had issues with removal of the steel center for some reason but after that one all the rest pushed out like they were made to do. Very good quality.
Glafiro Garza
Reviewed in the United States on May 29, 2021
Drilled 8 - 1 1/2 inch holes through 3/4 inch plate cutter performed as it should , did a great job. Make sure to use plenty of coolant
Bob
Reviewed in the United States on December 5, 2021
I hate to have to write this but I didn't have the great luck that others seem to have had. I bored one hole and half way thru the next, it stopped cutting, just spinning! I was spraying it with Roto-magic fluid the whole time. I looked at the end of the teeth and a groove was cut into them that had removed the sharpest point of the teeth..I can't say for certain that it was the tools fault, perhaps there was a hard spot in the metal?? I was going thru some C-channel about 5/16 thick and was using a mag drill made for these cutters.That single hole cost me $34.99. Really bummed about that. As a hobbyist, that stings a little. Now how do I bore the other 43 holes I need done??Guess I'll try my luck at sharpening it. (never did one of these before)P.S. I have many other annular cutters that I've used over and over again without a single problem. (not this brand)
Keith R Parkison
Reviewed in the United States on September 4, 2019
First time I have used one of these types of cutter, I drill alot of holes with my Jet Drill press and these things just cant be beat, I am cooling thru the center with Antifreeze and they dont heat up at all. 1 1/2" hole thru 1/2 AR50 plate in under 60 seconds.
Carol Van Hoesen
Reviewed in the United States on September 10, 2018
as expected
Recommended Products
$17.99
$ 8 .99 $8.99
$17.99
$ 7 .99 $7.99