Your cart is empty.
Your cart is empty.Product Description
Shawlo
Reviewed in the United States on June 11, 2025
Great product
Cris
Reviewed in Mexico on May 3, 2025
Funciona bien
Thomas Bradley II
Reviewed in the United States on March 9, 2025
Works amazing, worth every penny.
K. Siebert
Reviewed in the United States on December 21, 2022
15 amps. No way. I fix these and use this model often. The best you can get is 24v at 10amps. Otherwise a very useful device.
Bunnykiller
Reviewed in the United States on June 23, 2020
I needed a power supply to run a few TECs and this one did the job, infact it cooled off the laser too well, the heatsink fins on the laser began developing a light frost on them, now how cool was that? ;) I also used 2 of those motor controllers to fine tune the voltage requirements the TECs needed, so between this power supply and the 2 motor controllers, I got the TECs running better than I have ever seen.
Felipe
Reviewed in the United States on November 10, 2020
There is a serious issue with the original power supply that comes with the Ender 3. Mine did not get on fire but it burned a little the connector cable and the old power supply started to smell like smoke. I decided to stop printing and adapt this new one. Problem solved. No more smells of burned stuff in my printer. Everything is running good now.
Clancey
Reviewed in the United States on April 3, 2020
It was doing it's new job as a Anet A8 PSU upgrade, I have my power supply fused on my power socket, the fuse blew a few times before I went with one that could handle a slight bit more current, worked well for a week or two lots of test prints, then it started making this hissing noise when I'd power it on and before I knew it my printer shut of mid print. no singes of anything burnt, fuse was still good too. for the record I did check for shorts prior to adding a bigger fuse, I could not see anything wrong with my connections.
NotACop97Z28
Reviewed in the United States on May 17, 2019
The media could not be loaded.
S. QUINN
Reviewed in the United States on January 18, 2018
I'm using this power supply to power my iSDT Q6 Plus battery charger. I started with a re-purposed server power supply that did a great job of supplying a lot of current at 12v. The problem is that the iSDT charger is limited to 15A on input current so even though my 12v power supply can supply 750W of power, the 15A limit kept the charger from reaching it's full output potential. I was hitting a cap of around 10.5A powering this charger from 12v. Using this power supply I can now see the full 14A output of the charger and I'm not even stressing the power supply. at 14A output charging a 4S battery is it using roughly 250W. There is enough overhead in this power supply that I'll be able to comfortably charge even 6S batteries at up to about 12A,
Recommended Products