Your cart is empty.
Your cart is empty.Annette
Reviewed in the United States on March 4, 2025
Works to reduce noise
JFE
Reviewed in the United States on March 2, 2025
Top and bottom roller bearings did not fit at all so noise did not reduce much . Plus the locking washers were difficulty to put on without some creativity. Save your money .
Geno II
Reviewed in the United States on February 9, 2025
Plastic sleeves fit well, but locking clips are very difficult to install. No instructions were provided for either.
MICHAEL GROGAN
Reviewed in the United States on February 26, 2025
These were easy to install and really quite down my door.
Antone
Reviewed in the United States on February 21, 2025
Used with the DURA-LIFT (SKU DLMR6200ZZ) garage door rollers worked great.
Raz
Reviewed in the United States on January 7, 2025
If you are replaciong your steel garge door roller wheels for the much quieter nylon wheels, then it makes sense to add these sleeves to the wheels since you are removing the hinges and can easily add the sleeves to hopefully make the door even quieter. I am sure the sleeves reduce the movement and noise of the wheel shafts in the hinge for a quieter affect.
Badger
Reviewed in the United States on January 4, 2025
Had to remove the hinges to install this properly. The plastic sleeve makes it super tight to fit the roller, but can be done with enough patience. The retainer ring was next to impossible to fit by hand, ended up using a 12mm socket to hammer it in with the roller face on the floor.
Thomas P. Taylor
Reviewed in the United States on January 26, 2025
Impossible to install in my standard garage door. I purchased new nylon rollers and attempted to install the plastic sleeves. I first tried slipping them onto the roller after they were installed but they were too tight. I removed one of the hinges and removed the roller. I then successfully installed the sleeve and tried to reinstall the roller but the hinge socket was too tight to fit the roller with the sleeve installed. I tried to separate the opening a little with a screwdriver to no avail. I promptly boxed up the sleeve kit and returned them. I would NOT recommend these and feel the they are not worth the effort to try and make them work. You could probably accomplish the same thing by installing a piece of shrink tubing on each roller. The shrink tubing is thinner and would accomplish the same effect.
Lester Yuen
Reviewed in Canada on October 8, 2024
Should have listened to the previous reviews .They are slightly too narrow can only get about an 1/8 of the tube onto the roller .I tried soap and very little water in the tube along with some garage roller spray lube with no success, too bad.
Leyland Williams
Reviewed in Canada on July 26, 2023
Tight when installed causing roller to not float and accommodate any misalignment in the tracks
Recommended Products