Your cart is empty.
Your cart is empty. Specification
Model : 85C1-A
Material : Plastic, Electronic Components
Measuring Ampere Range : DC 0-50mA
Accuracy : Class 2.5
Work Temperature : -20~+ 50C
Relative Humidity : ≤85%
Installation : Vertical installation
Insulation strength: AC 50Hz, 2KV, lasted 1 minute
Voltage influence: When the rated value changes by ±15%
Mechanical resistance performance: can withstand acceleration of 30 m/s
Dimension
Mount Size : 2 x 1.9 inch / 52 x 49 mm
Meter Panel Size(Approx) : 2.5 x 2.2 x 2.3 inch / 64 x 56 x 60 mm(L*W*T)
Package Includes
2pcs x Analog Amperemeter with Pulse + Installing Parts
Product Feature
1.Measures current tool with accuracy of Class 2.5 ,Clear and easy to read scale and a button for fine tuning the dial.
2.Impact frequency 80~120 impact test per minute; 2 hours transport shock test.
2.Applicable to display panels and large switch boards installed in various control systems and power distribution systems to indicate related electrical parameters; Such as: AC and DC current, voltage, power factor, power, synchronization value, frequency, expansion voltage and overload current, etc.
Please Note
1.If the pointer is not in the 0 position, please use the 0-position adjuster on the cover to adjust the needle to 0 position.
2.The device should not be knocked or shaken.
3.Measures amper range of 0-50mA with accuracy of Class 2.5.
4.Clear and easy to read scale and a button for fine tuning the dial.
5.Suitable for electronic applications, auto circuit or other Voltage measurement devices.
Customer
Reviewed in the United States on September 19, 2023
First shipment arrived in envelope - fragile plastic bezel broken. Replacement order shipped in envelope - fragile plastic bezel broken. Tried to use anyway - one meter way too sensitive. One reads 5 ohms the other reads 150 ohms. Put my project back by a week.
James C Lamborn
Reviewed in the United States on May 7, 2023
I connected this in series with my 6.5 digit HP bench meter. It was right on at 7.7ma. I didn't test the upper end of scale. I gave it 4 stars since it's made in China. If it holds up for awhile, I'll give it 5 stars. To Sm : the polarity is marked, but only the minus terminal.
Sm
Reviewed in the United States on March 6, 2023
Both arrived on time and undamaged.Adjusted the 0 on both meters.One meter closely matches my DVM.One meter reads lower than my DVM.Would give 5 stars if the meters had the polarity marked on the terminals.Will use to monitor laser tube current.
rogwabbit
Reviewed in the United States on February 14, 2023
Great for experiments.
Customer
Reviewed in the United States on April 23, 2023
Used for a direct-reading piece of bench teat equipment; worked well enough.Compared to Fluke 87 MkIII wired in series, and it seemed to agree to an accuracy within the needle’s width, across the scale.It was more than good enough for the straightforward job I needed it to do.
Biao Liang
Reviewed in the United States on April 21, 2023
The washer and nut too big. Can not hole the wires. I use the meter is good.
David Turbeville
Reviewed in the United States on December 5, 2022
Fantastic meter. I use it to monitor 4to20mA process loops. I add a series diode to protect against reverse motion.
Recommended Products
