Shopping Cart

Your cart is empty.

Your cart is empty.

Linkstyle DC Volt Amp Meter Ammeter, DC 5-100V 100A Dual Display Current Voltage Meter Gauge with Hall Effect Sensor Transformer

4.3 (5) Write Review
Free shipping on orders over $29.99

$20.49

$ 9 .99 $9.99

In Stock

About this item

  • 2 In 1 Multimeter Panel: The volt amp meter can monitor real-time current and voltage, red indicates voltage, blue indicates current
  • Wider Test Range: Voltage measuring range: DC 0-300V. Current measuring range: ±0-100A. Power supply: DC 5-100V. Accuracy: 0.1V, 0.1A
  • Through-hole Measurement: The voltmeter ammeter with Hall effect sensors can measure bidirectional currents, regardless of direction. Note: decimal point indicates negative current
  • Reset Function: Press and hold the "reset button" for 3 seconds to reset, and 6 seconds to restore to factory settings
  • Reverse Connection Protection: If the positive and negative poles are connected in reverse, the device will not burn out, but there will be no display


Product Description

dc amp meter
ammeter
amp meter

volt meter

volt meter 12 volt

volt meter

Battery Voltage Meter

gary
Reviewed in the United States on September 3, 2024
I used this on my portable ham radio power supply for POTA. Easy to install. Accurate enough for most purposes. If you need a high degree of accuracy you are going to spend more money than this.
Jeff M.
Reviewed in the United States on June 2, 2024
Unreliable
Jessie
Reviewed in the United States on December 30, 2024
After testing quite a few batteries and dealing with many others over the years, this little meter looked to be something I could make good use of. So, it was ordered.It arrived in 5 days which was one day later than the estimated delivery date. The meter appeared to be in good condition.The meter is rather small. Meaning its display employs just 0.25" high digits. However, the digits are bright, have good contrast and are easy enough to read. The meter measures 1-7/8" wide, 1-1/8" high and 3/4" thick. The power leads are approximately 6" long and plug into the rear of the meter. The current sensor's "normal" leads are rather short. However, a 76" long replacement ribbon cable is included for remote sensing, if needed.One tip: After voltage is applied, there is a slight delay before the display produces a reading. If you are testing it to verify its operation, that delay might make it appear that the meter is defective. Just give it a second or so.
Customer
Reviewed in the United States on December 28, 2024
I can't speak to long term reliability yet, but it is working fine so far. I like that they include both a short 6" cable for the current sensor as well as a much longer one (about 6'). The cables are a rather small gauge and will not take a whole lot of abuse. This is best for fixed applications where the wiring will not need to be moved around regularly, and where it's not exposed to substantial vibration. I wouldn't recommend this for vehicle mounting, it's better suited for things like fixed solar.
Customer
Reviewed in the United States on November 10, 2024
Worked fine for a couple weeks. Numbers started flashing random brightness, then a week later apmmeter started reading random numbers. Junk