Your cart is empty.
Your cart is empty.Yukon Gear and Axle manufactures a full line of standard open and positraction carrier cases for a variety of applications. The castings and machining are kept to the highest of standards to produce a carrier which provides both high strength and tight tolerances for long life.
Okrider
Reviewed in Canada on August 30, 2024
Also bought a Yukon spider kit with new shims and pin and the pin did not fit the carrier. Had to grind the hole slightly larger to make it fit. Not sure if its the pin that is too large or the carrier hole is too small.
Jaime N Montalvo
Reviewed in the United States on February 18, 2023
Great quality product. Arrived quickly and just as described in the listing.This carrier fit perfectly into my 1999 Jeep Cherokee front axle and saved the weekend.
Tracy Knepp
Reviewed in the United States on May 31, 2021
The easy to install part of this is...setting up a Dana 30 front end isn't easy to do at all. Ever.
Matthew L Simpson
Reviewed in the United States on April 19, 2021
Once the magic happened and one arrived the quality looks good. I have not done the installation yet but I don't anticipate any issues
Kyle B.
Reviewed in the United States on February 11, 2020
Dana 30 Carrier is exactly as described with 0 run out. It was priced fairly and arrived quickly. Necessary if you plan to install gears numerically higher than 3.73 in a jeep that came with 3.55 or numerically lower gears stock.
Chris perrin
Reviewed in the United States on December 7, 2020
Didn’t take any pics but the carrier was spot on. Have had it installed for a few months now. Great price and very fast shipping. Would very highly recommend.
JF Lepage
Reviewed in Canada on September 7, 2019
Does exactly what it's supposed to do. Good quality, well machined
Cboyd
Reviewed in the United States on October 23, 2019
Don't do reviews often but hopefully i can save someone else from my costly troubles, after discovering my 4.88 gears were installed on a lower numerical carrier i ordered this to make my new setup right. The cross pin did not fit, i opened the hole a couple thousands and pin seemed to fit well so i threw it together. On my first outing i broke the cross pin in my locker that i had ran for 7+years with no issues. When i tore it down i discovered the pin had wiped out my brand new gears, as well as my locker. The pin seems tight when in both sides but has tons of play when in only one side. This allowed pin to flex and break. I should have gotten a different carrier when i noticed pin didn't fit, but yukon should have quality control. Do not buy this and get a spicer carrier. Now I'm $500 extra in a gear set that should be done.
Thomas
Reviewed in the United States on January 12, 2019
I installed new 4.56 gears in my 92 YJ, and could not shim factory carrier enough to get within specs. By replacing the carrier with this one, I was able to shim to specs in just a couple of tries. 0.002" from dead center.
Jeffrey Dean
Reviewed in the United States on February 26, 2018
Fits but you have to dremel the center pin hole the slightest bit have had it for 6 months now tho and it’s fine
Recommended Products
$265.00
$ 99 .00 $99.00