Your cart is empty.
Your cart is empty.Product Description
lksdjf
Reviewed in the United States on September 29, 2024
Not sure about the other sized tubing because I didn't try, but this tool will not double flare 5/8" copper pipe. It simply pushes the tubing out of the tool causing damage to the pipe. I tried the vice grip trick as others have stated but that didn't work either. In my personal opinion, this is definitely not a professional grade tool as the listing states. A brand new tool couldn't even perform one double flare on 5/8" soft copper.
حسن الزامل
Reviewed in Saudi Arabia on September 18, 2024
ممتازة 👍🏻
Super easy to install!
Reviewed in the United States on July 20, 2024
I’ve had quite a few flaring tools over the years this one was the best by far no fumbling everything locks together , dose all the flares you need for metric and standard lines, sturdy and well built , made great flares every time , slim and compact for storage
Peter R.
Reviewed in the United States on July 15, 2024
Kit had everything I needed
Thomas H.
Reviewed in Germany on June 24, 2024
Pünktliche Lieferung ! Produkt in Ordnung
Customer
Reviewed in the United States on June 16, 2024
Worked fine for 1/4 up to the max 5/8 copper pipe sizes. I only had one failure mode, one time I did not tighten the tool all the way and the pipe slipped. After that happened the same pipe kept slipping! You must cut away the portion that slipped because it became a smaller diameter! After removing 1/2 inch of pipe and tightening the tool all the way the fresh pipe portion did not slip.
Norman
Reviewed in the United States on March 4, 2024
I have owned other cheap basic flare sets. They all present the same problems centering the flare and slipping on the tubing. Even a high end brand did no better. This tool has a better chance of getting it done at the reasonable tool price. You will need to practice regardless what tool you buy.
Florick55
Reviewed in the United States on March 2, 2024
Worked once, tried to use again and the teeth inside the holding clamp don’t grab anymore
Bollaert
Reviewed in France on December 13, 2024
Utilisation normale manque de précision
Wild Bill
Reviewed in the United States on October 25, 2024
Made several brake lines for 1964 F600 converting to dual cylinder brakes. Tool worked perfect every time.
Don Schlitt
Reviewed in Canada on October 1, 2024
Works great and very sturdy
Mark Yang
Reviewed in Canada on December 21, 2023
I have made brake line with it successfully. It is easy and high efficiency. I have already installed the brake line to my vehicle. It works well so far.
sam
Reviewed in the United States on April 15, 2023
As mechanic you will learn something cheaper are better then expensive.. Ive probably got 6 brake tools like these hanging around my house. All those half box AutoZone sets . And it seems like I always loose the little black pieces or break them . I did 8 fitting with this set and didn't break on piece even know. I wish the cutter wasn't made on the cheap and was a little smaller . I bet I'll all the pieces will be found for months to come
Recommended Products