Your cart is empty.
Your cart is empty.Product Description
Frank
Reviewed in the United States on February 8, 2025
Not sure how it became Amazon choice, instruction is confusing with many grammar errors, the suction cup tool is basically unnecessary and useless, and the suction cups didnโt hold anyway. After using the suction cup tool, resin flew out and made a mess; and you have to apply manually afterwards which defeats the purpose of the tool. The plastic film flattened the resin and you have to act really quick otherwise noticeable excessive resin stuck to glass and hard to clean (the paper-metal flattener didnโt work). At the end of all the scrambles, the crack is still visible with a glob resin left. Two star instead of one star is because resin cured fast
Lankytojas
Reviewed in the United States on February 8, 2025
It did not work as advertised.
Laura Moody
Reviewed in the United States on February 6, 2025
The chips on my windshield are still highly visible after applying this.
Shan
Reviewed in the United States on February 25, 2025
Wish the liquid is good enough to flat penetrate into crack. Some liquids are less sticky and this is more sticky and speed to dry than anticipated. Liquid bottle is hard to press.
Patricia Dakshaw
Reviewed in the United States on February 20, 2025
Just used this product. The instructions are not very good, you will also need your brain along with ignoring the terrible grammar and spelling. Clean the impact area very well. Dig it out with the pin. Dont be shy. Without doing this well you will not get results. Apply the suction cup holder. When inserting the resin applicator you will need to lift up slightly on the suction cup holder to get it to take (if you understand how to use a screw). Screw until tight but not lifting the suction cups off the windshield. Drip in resin. Follow with the pressure stick screwing it in all the way as wellโฆ slowly!!! Let sit for 1 minute. Remove the entire piece. One drop on the curing sheet and lay over the hole. Let cure in the sun. Scrape area with razor blade to cleanITS NOT PERFECT!!! But as long as the impact hole is not in your eyeline, you should be happy with the results. If the bullseye or crack is in your eyeline- DO NOT USE ANY PRODUCT LIKE THIS AND REPLACE YOUR WINDSHIELD becausw you will always know it is there.
Joaquin
Reviewed in the United States on February 17, 2025
I followed all instructions. I had a simple hald inch crack and now it is more than 2 inches, due to the pressure. It didn't work AT ALL.
Tom McDonald
Reviewed in the United States on February 14, 2025
This doesn't work. The piece with the 4 suction cups attaches so close to the windshield that the part that is supposed to screw in can't get close enough for the threads to catch so it can screw down. So that middle piece is just flopping around because it can't get close enough to screw in place. So when you put the resin inside it, it just runs everywhere because that middle piece is loose and not held in place properly.
VHZA
Reviewed in the United States on February 10, 2025
Poor quality Donโt last much on glass. Donโt stick well.
Recommended Products