Your cart is empty.
Your cart is empty.Product Description
Information
Taps can be divided into straight flute thread taps, spiral flute thread taps, spiral point thread taps and thread forming taps. They are also divided into hand taps and machine taps according to the usage. Hand taps are operated by tap wrenches. Machine taps are suggested to be used with tap collets with overload protection. Recommended feed rate: General steel: 6-15m/min; harder steel: 5-10m/min; stainless steel: 2-7m/min; cast iron: 8-10m/min.
Straight Flute Taps
Straight flute design, downward chip removal, fast tapping with accuracy. Suitable for processing through holes or shallow blind holes.
Easy to Use
Used on drilling machines, tapping machines, CNC and milling machines. Use with tapping oil to get higher quality threads and more durable taps.
Coatings
Features just the base substrate without any additional coatings, suitable for wide ranges of applications.
High Speed Steel Taps
- High hardness and strength, good toughness
- Good wear resistance and heat resistance..
- Good process performance.
- Perfect for drilling and tapping aluminum, zinc, alloy etc..
Steve Nelson
Reviewed in the United States on February 5, 2025
Just what I needed.
Kelly Madigan
Reviewed in the United States on January 1, 2025
I used it to repair threads in an aluminum engine block. It worked as advertised and is reasonably priced.
Canauk
Reviewed in Canada on August 19, 2024
Tap is not made of hardened material and strips out
Linus and Luna of Santa Cruz, CA
Reviewed in the United States on May 12, 2024
Nicely made tap. Cuts clean threads in stainless. Much better quality than the cheap import taps. I have. The tap does have the material or country of origin marked on tap.
richard kilgore
Reviewed in the United States on February 29, 2024
great tool that works well for threads
Jeremy
Reviewed in the United States on October 30, 2024
quality tap, the business end did its job well.... my only gripe is that i had to use a crescent wrench to turn it as it would not fit in my standard tap turning wrench. over all great product
Customer
Reviewed in Canada on October 12, 2024
Works
KatDog
Reviewed in the United States on April 6, 2024
I had to bore out the center of a rusted bolt then used this tap to remove remaining portions. It did the job, patience and lubricant helped.
Rexford
Reviewed in the United States on August 22, 2023
I got a hold down bolt cross threaded when remounting the driver's seat of my 2006 Tacoma. The hold is 10MM in diameter and there are 1.25 threads per mm spacing between threads. This tool fixed my problem quickly and I was able to install a new bolt and now my driver's seat is fully secure.
T2jk
Reviewed in the United States on August 10, 2023
Tap arrived in time to make a repair and worked perfect
Mike.A
Reviewed in Canada on June 14, 2023
réparé des filet de miroir endommagé sur une moto Honda cb 1979
Customer
Reviewed in Canada on April 13, 2023
Worked great for re-tapping factory holes in a 2014 Tucson , to be able to install a trailer hitch.
Customer
Reviewed in Canada on December 7, 2022
Worked good for me. Decent enough quality.
Recommended Products