Your cart is empty.
Your cart is empty.Tap Plug 7/16"-20nf C. Made of shock-resistant and heat treated S2 steel for maximum strength and hardness, ideal for maintenance and repair work, manufactured in United states.
Fo-rasta
Reviewed in Canada on August 3, 2024
Cut threads nicely
DJG
Reviewed in the United States on July 18, 2024
Always be sure to use real thread cutting oil when you are tapping anything. And if the tap seems to slow down or even get stuck just back it off a half turn to clear the metal shavings, and keep doing this (and adding a bit more thread cutting oil) as it repeatedly slows down.
John Williams
Reviewed in Canada on June 14, 2024
Good quality medium duty taps.
G. Powell
Reviewed in the United States on February 12, 2024
I bought this tool for one job, and that was to retrieve the brass bushing on my starter motor. It worked perfectly with a sliding T handle tool. I have no idea whether the treads are aligned or not or how long it will last. But it did its job and I didn't have to pay a shop to replace the starter.
Jesse R. Stokes
Reviewed in the United States on September 23, 2022
I used this to drill a classic cars crankshaft so I could bolt the balancer on it. I have never done anything like that before but it worked great. My biggest tip is use lubrication, do small turns in and out repetively and you'll get all the life out of this with out stripping or breaking it
Brian
Reviewed in the United States on August 24, 2022
Used this 7/16-20 tap to thread the oil sensor hole in a mini bike engine. Worked as expected!
T. Drayton
Reviewed in the United States on May 5, 2022
Ordered taps from them and they arrived quickly and as advertised.
david m
Reviewed in the United States on March 20, 2022
Worked as it should
Alex Key
Reviewed in Canada on July 6, 2020
purchased to have in toolbox for refreshing thread on Nissan Altima wheel nuts
Larry D.
Reviewed in the United States on June 11, 2020
Tap to make threads good
danthesk8er
Reviewed in the United States on January 10, 2020
Works great for what I used it on. I was tapping holes in my Jeep JK frame for rock rails. The metal used on the frame is some insanely hard steel. With this tool and some tapping oil it made fairly quick work of this. I did about 10 holes and the tap isn't worn at all. After running the tap through twice, the holes are perfect for the 7/16" bolts I have.
Recommended Products
$24.99
$ 11 .99 $11.99