Your cart is empty.
Your cart is empty.Product Description
Information
Taps can be divided into straight flute thread taps, spiral flute thread taps, spiral point thread taps and thread forming taps. They are also divided into hand taps and machine taps according to the usage. Hand taps are operated by tap wrenches. Machine taps are suggested to be used with tap collets with overload protection. Recommended feed rate: General steel: 6-15m/min; harder steel: 5-10m/min; stainless steel: 2-7m/min; cast iron: 8-10m/min.
Straight Flute Thread Taps
Straight flute design, downward chip removal, fast tapping with accuracy. Suitable for processing through holes or shallow blind holes.
Easy to Use
Used on drilling machines, tapping machines, CNC and milling machines. Use with tapping oil to get higher quality threads and more durable taps.
Coatings
Features just the base substrate without any additional coatings, suitable for wide ranges of applications.
High Speed Steel Taps
- High hardness and strength, good toughness
- Good wear resistance and heat resistance.
- Good process performance.
- Perfect for drilling and tapping aluminum, zinc, alloy etc..
Jerry k
Reviewed in the United States on June 12, 2024
Bought this for building custom hotwheels and it is great.
Philip Lebow
Reviewed in the United States on February 11, 2024
Tape was sharp and cut clean after 12 holes
John Rutigliano
Reviewed in the United States on January 9, 2024
Does what I wanted it to do.
David Ferris
Reviewed in the United States on April 18, 2024
This broke almost instantly. I know it’s a small tap but almost no pressure broke this and then I had to try and break it out so I could order another one.
TechDude
Reviewed in the United States on January 6, 2022
I ordered two 2-56 spiral point taps from Amazon as I needed tools fast. Both taps broke even though I used the proper drill size of #47 (.0785") with tapping oil. I would not recommend for tapping steel. Very brittle. Next time I will go to my usual tooling supplier.
BBrown
Reviewed in the United States on March 30, 2021
A fine tool. Cuts threads accurately.
Ralphini
Reviewed in the United States on December 24, 2020
This tap is small and hard to hold. I chucked it into a 3/8 drill and used the drill to rotate the tap very slowly a couple of turns clockwise into a #50 drill hole in 1/8” aluminum plate. Then, I reversed the drill to slowly back out the tap so that I could clean off the chips with a small stiff brush. It took several more in and out cycles to get the hole threaded. A 2/56 screw went into the new threaded hole quite nicely.
Chris Clark
Reviewed in the United States on January 27, 2020
This little tap works great! Easy to use and seems very durable so far! I've been using this with some tap fluid and must say I'm very happy with the results.
mark
Reviewed in Canada on November 17, 2019
Works great
Recommended Products
$30.99
$ 14 .99 $14.99