Your cart is empty.
Your cart is empty.Product Description
Alberto O.
Reviewed in the United States on February 7, 2025
Worked great.
ccundiff72
Reviewed in the United States on September 25, 2024
My wife had brand new tires installed and the technician stripped a wheel bolt (Jeep) while trying to reinstall the new tires.. well, i got stuck with fixing it...I can't ruin it further so I ordered this tap and replacement wheel bolt (pack of 5 from Amazon).. worked great..cut like butter and I installed the wheel bolt and torqued it to 100 lb/ft..."click" good to go...now she has 5 wheel bolts on each hub.... this tap cut great...worth the money 👍
Jim
Reviewed in Australia on September 25, 2024
trade quality tool
Russell Foran
Reviewed in the United States on March 6, 2024
works great in hard wood
Jerry Jones
Reviewed in the United States on December 7, 2024
Tap worked great on Cast Aluminum chairs
Kevin
Reviewed in the United States on December 20, 2024
Worked great to chase old threads
G1923
Reviewed in the United States on November 25, 2024
Worked perfect
REAGUNS
Reviewed in the United States on October 22, 2024
Works as advertised.
Claire
Reviewed in Canada on August 23, 2023
Does the job
Viktor G Automotive
Reviewed in Canada on June 15, 2023
Tapped over 50 holes in 3/16" thick mild steel plate with the M6x1.0 tap. Was just as good on the last hole as it was on the first. Better than the overpriced Snap-On tap I had that broke after 25 holes. Would buy again.
VinnniE
Reviewed in Canada on February 12, 2023
Not the best I’ve seen but for chasing thread, it works fine. I do not intend to use it for threading a hole, but the way I used it, it’s good.
Roy
Reviewed in the United States on January 9, 2023
I'm going to start with the negative part of my experience with this tap. I ordered a M6 X 1.0 tap but when it arrived, it seemed to be larger than expected. The order form said M6 X 1.0 and the package said M6 X 1.0 but etched on the tap itself was, "M8 X 1.0." If I had just started trying to cut threads with it, it would have been a sad mess but I caught it from the start. Of course, the Amazon Prime return process was wonderful, amazing, quick and easy. They sent me a replacement, which was the correct size that time, and I sent back the first one. I can't mark a product down from that kind of mistake but it would be a good idea to check yours out first and well before the return period runs out.Using the correct size tap, I had an aluminum mounting block with two blind holes that came from the factory with threads that only went down about 1/2" into an 1" deep hole. For the type of application that it was, it may have been fine like that but I wanted to use longer screws and just get more threads involved. For my situation, this tap worked just fine but it was only cutting into not-hard aluminum. This was not one of the aluminum alloys that are much harder (such as 7075 T6). Please note that I read reviews where some people had broken their taps and also, I'm of the old school where you go forward 1/2 turn and then reverse two turns. I also used a decent cutting oil. Being a blind hole, I also removed the tap and cleared out the chips several times. That takes a lot longer then the way some people may tap a hole but I only had TWO holes to tap and wanted to play it as safe as possible.
Carolyn Rupke
Reviewed in Canada on April 10, 2023
Used it for my motorcycle.
Recommended Products