Your cart is empty.
Your cart is empty.US Stove 40076 Fire Grate elevates the fire for faster start-up and ash removal. It also aids in the combustion efficiency of the fire allowing air to get underneath the coal bed and improving the ability to be clean and heat green. Fits most Wonderwood Stoves including models 2941 and 2931. US Stove has been bringing warmth to homes across the nation for 140-year. US Stove has a wide range of Automatic Circulators, Plate Steel Heaters, Cast Iron Heaters, Pellet/Multi-Fuel Heaters and Gas Fireplaces from which to choose. The large selection of stoves and accessories will ensure warmth of your home with safe, quality products.
Jenna McLaughlin
Reviewed in the United States on October 8, 2024
Advertised size:11.3x10.5Actual size: ~11.5x9.75 beveled down to 9.625 and that's just the bearing nubs, it's not a solid rectangle, and much less than 10.5.The whole point of a size is so you can get the right thing :-/
Lester Thompson
Reviewed in the United States on January 13, 2024
Very good quality
Brenda
Reviewed in the United States on February 8, 2023
These fit perfectly in both our wood stoves. The only complaint I have with these and all wood stove grates are that they are not sturdy enough. When they get hot a stick of wood can bust them.
Bernard Warner
Reviewed in the United States on December 5, 2022
Advertised as .6 inches thick, barely half that. The one I just installed measured 5/16". (.31). You would think that for the price, they could at least give honest dimensions.
Kathy Bailey
Reviewed in the United States on October 27, 2022
Works well and easy to install but the price was a little expensive
Richard Nulton
Reviewed in the United States on January 20, 2022
I got these to replace a very old set of fire grates for my wood burning stove in my garage. After taking the old ones out in several pieces and cleaning everything up, these just slid right into place. They did seem to be just a bit narrower and shorter than the ones I took out, but only by about 1/8" in both directions. There was a bit of movement in them when first installed, but after getting some ash around the sides and possibly a bit of expansion they fit in there pretty solid with little to no movement now. I've had many fires in there since installing them with no issues at all. If anything, these are easier to clean off than the old ones due to how much flatter these are than the old ones. Anyway, a bit over priced in my opinion but overall I have no issues with these grates.
William Huto
Reviewed in the United States on November 20, 2014
I have the Wonderwood Model 2941 and this fits just fine. It takes two to completely replace the entire woodbox. One grate fills the woodbox halfway. Just make sure the built in side holders are free of ash and they sit nicely on them. And this is the best price I could find for these anywhere. Well made, heavy and when I removed the old ones, approximately the same weight and looks just like the original pattern of the old grates. Very pleased and can recommend this product to others. I've already noticed a difference in the heat from the stove.UPDATE: I replaced these grates in 2017 and now will be replacing them again this year. Based on this, these grates life expectancy for me (heating season from October thru May...way upstate NY near Canada) is 3 1/2 to 4 years. I burn approximately 20 cords of wood annually, and the grates become brittle at the midpoint in the woodbox. Its not a manufacturing defect, its the hot bed of coals combined with the weight of new wood being tossed in. Hope that this additional information is helpful. Their life expectancy will be determined by your area and use.
bful
Reviewed in the United States on November 12, 2011
Received part in five days. Just what I wanted. Correct part and fit stove just right. Think if I had more time to find one, could have found a better price!
Recommended Products
