Your cart is empty.
Your cart is empty.Material is case hardened 1018 steel with black oxide finish. 1/2"-13 Thread. 9/16" Table slot. 1-1/8" Base size. Measures 5/8" width by 7/8" height.
Central Florida Weld & Fab
Reviewed in the United States on March 27, 2024
I bought these to have extra T-nuts for an upcoming project. Whomever made these nuts need to look at how nut should be built...they did not thread these nuts all the way though the nut. To make it worse they used a tapered tap, you can only get the first few threads to catch in the nuts. I have to have them and had to run a tap through them all. Hard to make money when you have to fix new tools just to make them useable.
mozer
Reviewed in the United States on November 9, 2022
Many Asian Mill/ Drills should use these size T-Nuts. The 1/2"- 13 TPI studs allow for larger clamps.
Ron Hope
Reviewed in the United States on July 1, 2021
these are the industrial nuts I needed.
Engineer
Reviewed in the United States on December 30, 2021
Also, these are not threaded entirely through by design to prevent you from damaging your T-slots
Rob
Reviewed in the United States on March 25, 2015
While they are what they are, I had to clean out the threads on everyone. They are setup not to thread all the way through, which is how they should be so that you don't damage the slots, but these were dirty enough that I couldn't get a bolt into them even half way.Once cleaned out ok. I'm just tired of un-chiniese-afying tools. I don't care where they are made as long as they are made well. I give these a C- grade.
Recommended Products
