Your cart is empty.
Your cart is empty. Feature:
Material: Made of high quality carbon steel, adapting quenching heat treatment, the hardness is up to 35HRC.
Size: M8
Length: 24mm; Height: 13mm
Top Size: Width: 12mm, Height: 6mm
Base Size: Width: 19mm, Height: 7mm
Package Include:
8pcs T-Slot Nuts
ML Roak
Reviewed in the United States on August 11, 2024
To be upfront. I had to mill the bottoms down till the flange was a thickness of .212 inches. I knew that I was probably going to have to before I bought them so I’m not upset about it. Now that they are milled down they fit my t-slots perfectly, and the 3/8 bolts from my hold down kit that I already had fits perfectly. Still easier than making them From scratch.
milmac
Reviewed in the United States on May 11, 2022
These supposedly fit a 12mm T-slot. Well, guess what. You can't fit a 12.40mm wide nut into a 12.00mm slot. All actual dimensions vary from 0.02 to 0.40 mm over the stated dimension, in every direction. No two pieces are the same. Holes are off center. The flanges have round shoulders -- these have clearly been produced with dull, inferior tooling. The base is not 6mm high as stated; it's more like 6.1 which will not fit into 6.0 clearance, and the rounded shoulders increase that to nearly 7.On top of all that, while the nuts actually do have M10-1.5 thread as advertised, the package is mislabeled as 3/8"-16.Don't waste your time. The only thing these might be useful for is fishing sinkers.
Customer
Reviewed in the United States on August 24, 2021
A perfect fit for my milling table.
Customer
Reviewed in the United States on March 3, 2021
The T nuts will have to have the bottom sanded slightly to fit in the slots of my Grizzly G0781 Milling machine. Aside from the clearance issue which is due to a coating on the bottom of the mill these t-slot nuts are well constructed and should work perfectly.
MaxVideo
Reviewed in the United States on September 16, 2020
I was a little worried that these would be too big to fit into the slots of my Micro Mark mill (the same Sieg X2 that is sold by Grizzly, Micro Mark, and many others). But they just fit and slide very smoothly without modifying them. The M10 threads are the correct ones for the hold-down bolts and studs provided in the "52 piece" hold down set that Micro Mark sells. These are hardened steel, of course, so you can really lean on your hold down bolts with a wrench and the threads on these don't suffer the slightest damage.
Michael Z
Reviewed in the United States on February 8, 2020
Was hard to find the correct size t slots for my machine that would work for what I needed. These fit the bill but when I received them they are defiantly not of the highest quality. There was almost no deburring done to them and they were pretty rough. After some work on my part they do exactly what I need them to do.Don’t buy these expecting to get high quality T-Slot nuts but if your willing to do some work to them after you get them they will work.
Customer
Reviewed in the United States on February 11, 2020
I'm using these in my mini-mill 12mm T-slots, slight filing is needed to cut the rough edges but that was expected :-)
Mac
Reviewed in the United States on October 20, 2019
They fit my mini mill great. Just ordered another pack they are that good and inexpensive.
Recommended Products
