Your cart is empty.
Your cart is empty.Product Description
Product Parameter
2 Position 2 Way Solenoid Valve 2V025-08
- Voltage:DC24V
- Inlet = Outlet = 1/4"NPT
- Working Pressure Range:25-116Psi
- Working Temperature:32~140℉
- Operation Type: Internally Piloted Acting Type
PRODUCT FEATURE
High Frequency Guide
- Pure Copper High Precision Pilot Head Up To 5 Times/second Air Valve Precision, Smooth Without Stuttering.
Electrode
- Grounding Wires Can Prevent Static Electricity or Leakage on the Surface of the Equipment, Especially for High-power Appliances.
- Light on = Working.
Strong Sealing Performance
- High Heart Rate Sealing Ring, Self-moistening Sealing Rubber, Close to the Valve Spool Seamless, Strong Sealing Performance.
Simple Function Diagram
- In The Non-energized State, The Inlet And Outlet Are Closed.in The Energized State, The Inlet And Outlet Holes Open.
- Pay Attention to Check Whether the Components Are Damaged During Transportation Before Use, and then Install and Use.
- Please pay attention to whether the use environment meets the product requirements (such as pressure range, temperature range, voltage, etc.).
Tinkerman
Reviewed in the United States on August 22, 2024
These work just as well and last just as long then much pricier ones I used for our projects.
Chains
Reviewed in the United States on July 22, 2024
Been using this over 6 months on my semi in the open elements. Works great!
travis blackshear
Reviewed in the United States on July 2, 2024
Silinode works but doesn’t tell you how to wire or hook leads up so trial and error a lot
Maya D.
Reviewed in Mexico on February 20, 2024
dejo de funcionar al med de uso ya no cerraba se quedaba abierto todo el timpo
Roland Gassmann
Reviewed in the United States on December 29, 2024
the valve has a small leak when closed. I did opened the valve and the rubber gasket is poor quality and dose not close competently. that where the leak is coming from.
Andrey
Reviewed in the United States on October 25, 2024
Must have for each owner of laser cutter machine
DWG
Reviewed in the United States on April 27, 2024
Purchased this to construct a temperature controller for a low-pressure steam heater. So far it has worked perfectly and with the PID it supplies the necessary heat in our production area. Tailonz products are well built and cost effective.
PostMo Woods
Reviewed in the United States on February 15, 2023
I'm using this as a trigger to run air to a pneumatic drill. For that purpose, it is performing very well. I haven't had to replace it and it's performed well over 200,000 times by now. I expect it might do a million plus cycles similar to other solenoids from this company. Recommended, though your mileage may vary if you have to hold it open for a long time or something like that, might get hot. I wouldn't necessarily think that would be a good idea, but for providing a puff of air, it's great. Total recommend.
Ronald Rodriguez
Reviewed in the United States on December 7, 2023
I got this to help with my air assist on a laser. After wiring it wouldn’t turn on so I thought it was my wiring. It was not after careful inspection. It was the unit that was broken. Power came in but the switch did not work. Replaced it for the pre wire one and that one worked well. Over all it’s good just test before fully assembling.
Cliente de
Reviewed in Mexico on April 23, 2023
trabaja muy bien lo instale en las cornetas de aire
Recommended Products