Your cart is empty.
Your cart is empty.U
Reviewed in Canada on September 20, 2024
Usually, one of these lasts a couple seasons. Does the job well enough for the price. This one lasted one day.
Customer
Reviewed in Canada on August 13, 2024
I found this to be better than my vortex cleaner, no cords and it vacuums great. I was a little skeptical at first with everyone saying it doesn't clean the whole pool. I have an on ground pool and if set up properly and adjust the jets and after a couple hours adjust them 180 degrees it clean great. I only wish it came with 2 diversion valves for the jets because I have 2 jets (can't find where to get another one the same as the one that came with the vacuum).
Todd Tremeer
Reviewed in Canada on July 9, 2024
I've been using this vaccum now for a couple of weeks and it works fine. It doesn't climb walls like my former Kreepy-Crawly but this new machine cost a lot less. The vacuum climbs the slope between my shallow-end and deep-end of the pool fine and that's all that matters. The hose is fine but ideally I need two more hose pieces for the vaccum to reach fully across the shallow end of my in-ground pool. My pool is an average size pool. Assembly of the pool vacuum was easy but I had to slightly enlarge the hose where it fits into my pool skimmer's vacuum plate. Enlarging the soft plastic hose was however easy enough with a sharp knife and sandpaper.
Lance
Reviewed in Canada on June 30, 2024
There is not enough hose sections in the kit to cover my 18'x36' pool. Luckily my old Kreepy Krauly hoses work with these. Needed an additional 3 sections to cover the pool. Also, difficult getting the weights right so that it goes everywhere. Suggested weight positions don't work. Hopefully over time I'll find the right combination.
Normand Chiasson
Reviewed in Canada on October 19, 2024
I just got the pool vac a week or so ago, So far no dislikes, I like that it starts working on its own and so far has been going all over the pool FYI my pool is an 18’ x 36’ inground
Stephanie Hunnell
Reviewed in the United States on August 14, 2022
After 24 hours of it running it did not clean the pool. Just the middle. We had one similar to the one we bought. It made it around the entire pool.. Money wasted.
Lynne L.
Reviewed in the United States on January 4, 2020
I purchased this generic version of Kreepy at a significant savings over the original Kreepy and have used it for several months. This item works just as hard as the more expensive cleaner and I have had no problems with it. It performs very well and I would purchase again.
Bryan
Reviewed in the United States on June 10, 2018
It makes a lot of vibration but needs constant babysitting. Not worth buying.
JK
Reviewed in the United States on July 20, 2017
Works great!
Steve L.
Reviewed in the United States on June 21, 2017
Works well once you get it going. The toggle in the bottom that goes back and forth and causes the machine to move, won't work about 80% of the time when it's first started. If you will pull the machine to the top of the water, upside down, without letting the suction break the top of the water, you can then take your finger and move the toggle back and forth a couple of times (jump start) it takes off and does great.Sounds like a pain in the fanny, but it's not a biggie. If it wasn't for that, I would have given 5 stars.
Shelley K. Noble
Reviewed in the United States on June 14, 2017
2nd time for this review- pool cone was not the right size for my pool and I have to use my old one. I was disappointed that the design wasn't functional for my pool but it works well anyway. Good quality and great product other than the design flaw in the pool cone.
Sam Chap
Reviewed in the United States on April 20, 2017
Works amazing for the price! I leave mine in all day and in no time all the leaves and sand are gone. Love it and it came very fast and was simple to put together.
Roger
Reviewed in the United States on April 18, 2017
I have to pick it up off the pool floor every day to get it started or it just sits there. I even slid the weights to the back and this still happens. Once I manually start it though, it works great and is easy to assemble
Recommended Products