Your cart is empty.
Your cart is empty.LSI 9211-8i SAS HBA controller cards. Flashed to Avago / LSI 9211-8i IT (Initiator Target) firmware version P20 (specifically 20.00.07.00).Comes with ventilated standard full height profile bracket. Firmware and bios flashed, and fully tested with all 8 SAS lanes. LSI 9211-8i IT (Initiator Target) firmware version P20 (specifically 20.00.07.00), MPTSAS2 BIOS ROM version 07.39.02.00
Beau K.
Reviewed in the United States on January 23, 2025
Just as described. I use it for my HP Proliant DL380 G7 server.
Joe
Reviewed in the United States on June 10, 2024
Plug and play with Windows 11, no diver or software install needed, recognized both of my drives with no issues.
Gregory Jones
Reviewed in the United States on January 31, 2024
Worked flawlessly and verified flashing was legitimate to the latest version compatible with Unraid 6.x
Michael Bernat
Reviewed in the United States on January 31, 2024
I run a Proxmox hypervisor and this card is attached to 8 drives for storage on my network. The card it replaced I got for $30 on eBay. I can tell by looking at this, it is a genuine LSI part.My hypervisor uses ZFS to manage storage volumes/arrays, and the old card gave AER errors that would flood my syslog and when I connected this card, all the errors went away. Like magic, this just works.I wish I bought this in the first place. This was entirely worth the $80 paid to enable SAS on my server without errors.---------------------If any of you are still reading, and might be curious...I have 3x HGST 4TB drives in a ZFS stack (RAID 5) for an effective 8TB storage with 1 failure.I have 3x Seagate 12TB drives in a ZFS stack (RAID 5) for an effective 24TB storage with 1 failure.All refurbished drives because I'm pretty budget conscious.
Ann Marie Rosenbecker
Reviewed in the United States on September 26, 2023
I used this to add more hard drive controllers to my motherboard. I have a Plex media server setup and needed to go to 4 hard drives. I found that one of the ports on my mother board did not work. Bought this expander and moved the drives to it and it fired right up. I have 4, 14Tb HDs in my system currently but the system has space for 8. I doubt I will ever get there but this card should cover what I need. I consieer this a good purchase.
Mr.
Reviewed in the United States on July 27, 2022
It was plug-in-play works good on Windows 10… Very Happy
Eric
Reviewed in the United States on June 20, 2021
Worked good, could have had instructions..I tried the wind slot first.
Steven Hailer
Reviewed in the United States on March 7, 2021
I used this card in unRAID to add support for 8 HDDs in IT Mode. Did not have to change anything or do any setup. Card recognized first boot, unRAID found the four drives I have and everything worked ! Card comes flashed to IT mode so it’s perfect for adding 8 more hard drives to whatever you are running...Often you hear about fake LSI cards, the one I received says LSI in all the right places so it looks 100% real to me !
Recommended Products