Your cart is empty.
Your cart is empty.
Solid Carbide Spiral Router Bit with 1/4 inch Shank and 1/4 inch Cutting Diameter, 3/4 inch Cutting Length, 2-1/2 inch for Total Length;
Flat Top with 2-Flute, Material: HRC55 Carbide with TiAlN Coated;
For CNC, Engraving Machine.Carbon Steel, Mould Steel, Inconel, Stainless Steel, Titanium Alloy etc;
The Route Bit Suit for CNC Router and Makita, Bosch, and Any Brand Plunge Router with 1/4" Collet;
End Mill Bits are Suitable for Side Milling, End Milling, Finish Machining, etc.
Philippe
Reviewed in Canada on February 10, 2025
Aluminium will stick to it like there's no tomorrow.
Customer
Reviewed in the United States on December 28, 2024
I buy these quite a lot. Accurate 1/4" (most others bits are less than 1/4"). Shallow flutes create solid chatter free cuts. Deep flute bits are loud and chatter.
joe zaaffino
Reviewed in Canada on December 21, 2024
Cut’s great
Pete
Reviewed in Canada on August 25, 2023
as described work good
Skitters
Reviewed in the United States on May 12, 2023
These leave a much worse finish than the usual 1/4" 2 flute straight bits I use
Matthew
Reviewed in the United States on January 5, 2023
Nice set of bits, very sharp. I have been using these for hogging out material from hardwoods on my x carve. I've run 40ish hours on my first bit and still cutting well.
Dylan
Reviewed in the United States on August 14, 2022
These are amazing for what I need them for. So far I've ran this endmill through this job 2 times. The program is just over an hour making it around 2½hrs of use in total. This bit is still cutting like butter and ready for the next job. These are the only endmills I will buy from now on. Don't go spend $60 on an Amana when you can get 5 of these sub $40. Just stop searching and buy these. Thank me later.....your welcome!
andy
Reviewed in the United States on March 23, 2022
I milled the 2 aluminum pieces with one of these end Mills and it's still sharp. The black piece was from another time. These end Mills are sharp. They get into aluminum with minimal radial force. Nice chips. Smooth to the touch surface finish on the parts. I can't comment on life span at this point but based on the two pieces I made the value is definitely good.
Woodnuts
Reviewed in Canada on November 4, 2022
These bits work very well in my palm router.
Richard
Reviewed in Canada on October 22, 2022
Bon outil
s
Reviewed in the United States on July 9, 2020
Only have used them a few time but seem to be pretty good.
M. Peterson
Reviewed in the United States on June 21, 2020
Working as expected
argiope
Reviewed in the United States on December 7, 2020
This is a great value. They may not be the best bits we can buy, but they're excellent bits at this price. I just ran one for 7 hours straight on solid walnut and the edges of these 1/2in boards are clean as any bit costing 5x more. The bit still seems sharp and ready for more.
Recommended Products
$22.99
$ 10 .99 $10.99