Your cart is empty.
Your cart is empty.Product Description
Shars Slotting Saw Arbor R8 shank
- Part#: 202-1049
- Fits slotting saw with arbor holes: 1/2, 5/8, 3/4, 7/8, 1"
- Shank diameter: 1/2"
- Overall Length: 5-3/32"
- Rust resistant black oxide finish
Saw Blades NOT included
- The blades are firmly secured in position with a hex head screw
- The spring loaded mechanism readily accepts saw blades with hole diameter from 1/2" to 1"
Ruth N.
Reviewed in the United States on September 28, 2024
I use this arbor with 6 inch diamond discs to sharpen lathe tools, chisels, etc. I mount the system on my lathe. Runs very true and sharpens the tools very fast and leave a fine edge. For less than $50 I got the arbor and 9 disks of various grits. The only grits I really need are about 200 and 2000. I wrote a review for the disks and I notice that several other people are using the same system for sharpening tools.
Arnold Roberts
Reviewed in the United States on November 27, 2024
Generally, the products I have gotten from Shars has been acceptable in quality and function but not this time. I purchased this arbor to use for a slotting saw operation the runout was so bad it jammed twice when I checked it with an indicator it had .005 runout, measured the saw hole supporting surfaces and they were .004 undersized making a total .009 runout the cap and retaining screw tighted so much that I had to use channelocks and a cheater bar on the hex wrench to coax it loose Dont waste you $ on this.
MGHimages
Reviewed in the United States on October 18, 2024
Just like many Harbor Freight tools, this arbor is not a tool you want to make a living with, but works fine.You get what you pay for.With that said...Put some grease or anti-sieze on the screw, cup, and body where everything meets up.I used this once, and now it won't come apart. I tried torch heat, penetrating oil, impact socket, channel lock, EVERYTHING I had at my disposal...but the installed blade is now a permanent part.When the blade wears out, I have to trash the whole thing.This situation is likely from allowing the arbor to rub against the aluminum material I was cutting a slot into. Apparently the friction welded everything together.Lesson learned.
Roger Brown
Reviewed in the United States on April 15, 2024
Seems to be made nicely. Works fine.
Badrat
Reviewed in the United States on September 24, 2022
Nice tool, worked well. Only drawback it works best with a 1" arbor cutter.
Clint Sare
Reviewed in the United States on April 19, 2022
This holds blades up to 1/4" thick with arbor holes between 1/2" and 1". Almost all of the blades sold on Amazon are metric. A blade with a 22mm hole can be used but will not be centered properly.
Network00
Reviewed in the United States on September 10, 2021
Slitting parts for a model steam engine.
Customer
Reviewed in the United States on July 28, 2021
good
Recommended Products