Your cart is empty.
Your cart is empty.If you want perfectly flush joint lines for your stile and rail doors, setting the proper router bit height is essential. Even the slightest misalignment can mean significantly more sanding time after the doors are assembled. These setup blocks make setting the height easy. Simply set the block on the table and raise your router bit until the profile is lined up perfectly with the profile in the block. One side of each block is machined for stiles, the other for rails, meaning you'll never have to dig around for a matched pair. Features: Set your stile and rail router bits to the precise height, every time!Simply raise the router bit through the table and align it with the profile on the blockRail cut on one side and stile cut on the opposing side
JWG
Reviewed in the United States on February 1, 2025
Purchased the router bits with the setup jigs. Seems like there’s a lot of play when adjusting the bits. Not sure it was a good buy.
D. Bennett
Reviewed in the United States on June 28, 2023
I have used this a couple of times to setup my router bits and I have discovered that the best way to setup your router bits for tongue and grove cuts is to setup the router bit height by height, use a ruler and mark off center, cut the tongue then use the piece you cut to mark off the grove. This setup jig doesn't work with every router bit, so save money and time, measure and setup.
Recommended Products
$14.99
$ 7 .99 $7.99
$12.99
$ 5 .99 $5.99