Your cart is empty.
Your cart is empty.
Features :
Brand new and high quality.
Great for Sinking 90 Degree Holes into Wood and Soft Metals Countersunk Screws and Fixings.
all Commonly used Sizes
Including 12mm, 16mm & 19mm, all with 1/4" Hex Quick Change Shanks to Facilitate Fast Changing with a 1/4" Quick Chuck System.
Heat Treated Carbon Steel Blades Ensure Good Tool Life.
Suitable for all Woods and Soft Metals
Dia:12mm,16mm,19mm / 0.47'' , 0.62'', 0.74''
Length:6.35mm (1/4'')
Material:Heat Treated Carbon Steel
What You Get:
1 Set Hex Bit (3 pcs)
Fella
Reviewed in the United States on March 23, 2023
Does an excellent job with wood, metal and plastic.
Lar Bear
Reviewed in the United States on December 3, 2023
The price is unbeatable but you get what you pay for. These are not machined well. The metal is soft.I was actually expecting these to be higher quality. They'll countersink your screw heads but not for long.If you are a professional these are NOT for you. Home owner drilling 10 holes they'll work. If your looking to countersink 500 screws on your deck forget it.
Gregory A. Pless
Reviewed in the United States on November 14, 2022
They are made with the worst metal, look like they have been in a rock tumbler, and are unevenly cut. Other than that, they are great. ;-)
Spencer in Seattle
Reviewed in the United States on August 13, 2017
The media could not be loaded.
Johnny M.
Reviewed in the United States on February 3, 2017
It's exactly what I expected. On time and in good shape. Works well. Thanks
C. Owen
Reviewed in the United States on April 15, 2017
I honestly don't know what would differentiate a good countersink bit versus a bad countersink bit, other than just not doing what it's supposed to.I am happy to report that these bits work extremely well (I've only used them on wood), and are very easy to control. You will no have problems with runaway holes or over-sunk cavities.I did notice that sometimes the bit caused minor fiber fraying in the wood, but nothing that wasn't fixed by 5 seconds with 120grit.
Customer
Reviewed in the United States on July 14, 2016
Very useful when gluing/screwing 2 sheets of 3/4 inch plywood together. When you need to clean out the pilot holes, where the boards meet, this is just the ticket. You need to clean up the pilot hole tearout or the sheets of plywood will not mate correctly.
EKrueg
Reviewed in the United States on October 19, 2016
Eh, these countersinks are just ok. They are not very sharp, but get the job done somewhat acceptably. I will not buy again when my current ones wear out (which isn't going to be too long).
Recommended Products
$29.70
$ 15 .99 $15.99