Your cart is empty.
Your cart is empty.Product Description
Beanbaggirl
Reviewed in the United States on September 12, 2024
This light stand seems to be fine in terms of quality, it just didn’t work for my current setup for my aquatic turtle.
Andy L. Simpson
Reviewed in the United States on December 15, 2024
I liked it because it was like it was shown in exactly what I was looking for for the tank.
Dmgv
Reviewed in the United States on October 12, 2024
Overall design was practical but when tightening the knobs, it easily stripped and now one part is loose, allowing the metal rod to slide through easily. I think the knobs and the part that holds the rods should’ve been metal as well and it would be perfect.
Rodrigo Pichardo Benítez
Reviewed in Mexico on July 18, 2022
Quería esta base para colocar las luces de un tortugario grande ovalado, por lo que no es rectangular como una pecera y sus dimensiones son grandes.La base no se adapta al lugar, está endeble y las tortugas fácilmente podrían tirarla, no tiene pinzas para sujetar a la base, y hay más peso arriba que abajo por lo que no creo que sea seguro utilizarlas.Estoy muy descepcionada, esperaba tener que adaptarlas un poco, pero para que sean útiles tendré que cambiar la base y ajustar que no exista ese juego con las lámpas. Lo venden para que se pueda adaptar a más grados, pero no agregan una manera para fijarlo en el lugar que tú elijas.Insisto en que es súper inseguro para tortugas, los que tenemos estas mascotas sabemos que son fuertes, curiosas y trepadoras, por completo es una mala opción este producto.
Bec E.
Reviewed in the United States on January 31, 2021
The media could not be loaded.
SamHomicide
Reviewed in the United States on July 19, 2020
This is one of the best things I purchased for my bearded dragon tank. He was upgraded to a very large tank and one heat lamp wasn't going to be enough to keep his tank lit and warm on one side. And I'm always sceptical to rest heat lamps directly on the wire. This was easy to put together and holds my lamps in place. I can easily adjust it and I love it.The only downside i will out is that if you have to take the stand completely off it will be difficult just for the fact it has a little foot on it that sits under your tank. So you'll have to lift your tank to move the stand.
James W.
Reviewed in the United States on December 9, 2020
Good quality dual lamp stand that will save some of the cost of buying two. I've seen several bad reviews on the directions being hard to understand, the stand not going under the tank and bad set screws. Firstly you shouldn't need instructions to set this stand up...it's pretty basic. Secondly it specifically states in the description that it includes rubber feet if you need to elevate the tank. The set screws for lamp height adjustment are pretty bad, but after reading reviews I was prepared for this. I removed them and examined the threads, then made sure they were aligned perfectly straight before threading them in. If you just thread them in as they set when you open the box they will more than likely be cross threaded and not work properly. They definitely need to consider upgrading to metal screws. If you have a long tank and are trying to cover too large of an area with one lamp stand this probably wouldn't work for you, order two single lamp stands. I'm using these on both of my vertical gecko terrariums and they work and look great.
Kirsten Biefeld
Reviewed in the United States on October 21, 2020
I have a 50 gallon tank for my sulcata tortoise and this definitely has helped more than other lamp holders I have used. Previously I bought two separate lamp holders that stuck to the side of the tank, which were $20 each. While this worked fine for my heat emitter during the night, my 160W powersun bulb lamp was proving too heavy and was compromising the strength of the stickers that attached it to the tank. I was worried it would fall into the enclosure since I can't use a lid in case the powersun bulb would overheat. This dual lamp holder both makes it easier to support both lamps while alleviating my worries of a lamp falling. I can also have my lamps at two different levels as well, which is great for tiering my lamps, and I can move either around the tank as needed. The attachment for the lampholders can go a lot higher than my tall 50 gallon tank as well, and has been the only lamp holder that I have seen that can easily reach this height. I can also take the lamp holder off and use it for a smaller tank for traveling, which is a great bonus.When I first received the lamp holder in the mail, one of the adjusting screws was broken off in the socket. I couldn't get it out, but the seller was very quick with a response when I reached out. I was able to easily get a replacement.
AL DIOVANNI
Reviewed in the United States on October 18, 2020
this basking light bracket was for our pet bearded dragon. And we have the typical 40 gallon terrarium.i have a dual--the lights are connected together; they are not separate.This bracket was very hard to install (took many hours of pain) even though i followed all of the instructions because design was terrible: rubber rings allow the metal hooks to slide out--that's no good: hence i had to add 1" hose clamps so they wouldn't slide out; and those screws were 1-time-only plastic low-quality junk and wouldn't go back in so i had to use my own bolts but they didnt grab the metal pole in every case so then i had to use duct tape--i was considering drilling a big hole in the metal poles and then screwing my bolt into the hole but metal pole looked too delicate and too poor quality to hold the bolt. Also the lazy arms did not stay at 45 degree angle and kept squishing in, because i have a dual; so probably this product does 't work for a dual BUT PRODUCT ADVERTIZEMENT SAID IT WOULD WORK FOR A DUAL--hence this was misleading marketing. Finally i needed the lazy arm to go out farther but it could not and company did'nt provide any additional lazy arm extenders--that's no good.Finally I saw where this product was made: China; and then I understood the reason for the poor workmanship and low quality: China is famous for this and for parts that easily break and/or don't work and for poor quality and substandard workmanship. Buyer beware: Dont buy this product.
Recommended Products