Your cart is empty.
Your cart is empty.
Adhesive backed heat shield made from crushed volcanic rock, Heat shield Products, it has heatshielding capabilities with a carbon-fiber look. This insulator helps to reflect and dissipate heat, making it perfect to be an airbox heat shield or heat shield barrier to protect the paint on your carbon-fiber/fiberglass hood. Due to the natural chemical and acid-resistant properties of basalt (a mineral from volcanic rock).
BSTFLEX adhesive backed shield may be used on a firewall to shield radiant heat, and is also perfect to shield heat in transmission tunnels. It is also better to use BSTFLEX adhesive backed shield on applications where there is little airflow, making it a superior insulator to aluminum and gold barrier fabrics in these conditions. BSTFLEX adhesive backed shield withstands 1,200 degrees F direct continuous temperatures and 2,000 degrees F intermittent.
FEATURES:
Capable of reducing up to 80% of radiant heat
Helps shield fire walls, hoods, body panels, floor boards
Adhesive backing sticks to almost any clean surface (not recommended for rough or unfinished fiberglass/carbon)
Bulk rolls available
Why don't you recommend using adhesive backed shield on rough, unfinished fiberglass or carbon?
A. Self adhesive backings cannot fill in the surface irregularities that occur on unfinished glass or carbon. For these applications, it is better to use a spray on adhesive
Can I cut the adhesive backed shield and "overlap it"?
A. Heat Shield cuts easily with a pair of scissors of a utility knife. We do not recommend trying to overlap the heat Shield, because of it's coating. The coating may prevent the adhesive backed shield s adhesive to stick
BSTFLEX adhesive backed heat shield uses:
Hood
Firewall
Floor pan
Fuel tank
Transmission tunnel
Amazing-Deals
Reviewed in the United States on February 5, 2025
Positioned under motorcycle seat to reduce heat from engine. Was able to shape heat shield to fit unique contours. The basalt fibers are structured like carbon fiber weave and appear golden in sunlight.Strong adhesion so it's easier to cut while still attached to wax backing paper, but you can trim as you install
Alexis
Reviewed in the United States on February 24, 2025
ES MUY BUEN PRODUCTO,LO UTILISE EN UN CUSTON PARA EL INTAKE DE MY F450 Y SOPORTA ALTAS TEMPERATURAS MUY BUENO LO RECOMIENDO.
Ted Morphis
Reviewed in the United States on February 15, 2025
Very easy to cut to fit and install! Just make sure a sharp cutting tool.
E
Reviewed in the United States on January 23, 2025
Saved my TV from getting too hot. Looks good and blends in well.
Charles Carr
Reviewed in the United States on February 7, 2024
I purchased this product to put on top of my air fryer oven. The oven gets extremely hot on the top surface, and I was looking for a way to reduce the surface temp to enable storing items on top of the oven. This did reduce the heat, to a small degree, maybe 25-30%, but was disappointing in performance when compared to other heat reducing pads I've used. It still left the oven hot enough that I couldn't rest my hand on it. So this may not be the best option when looking to reduce heat by a significant amount.
Neilio
Reviewed in the United States on June 28, 2023
I do t know how well it works but know I got screwed out of 1/2 inch each direction
Customer
Reviewed in the United States on May 18, 2023
Adam and Laura
Reviewed in the United States on December 1, 2023
A couple layers of this and a layer of a high temp silicon type foil face along with web adhesive is better than the loose fiberglass insulation which had fallen apart. Leave a 1/2" gap around the tubes and you'll be golden.Ductboard will burn if it's too close and fire stop foam will burn as well.Just use a couple layers of this and some silicon type foil face high temp mat and you'll be golden.
Recommended Products
