Shopping Cart

Your cart is empty.

Your cart is empty.

POCREATION OLED Display Module, SSH1106 Lightweight High Resolution OLED Screen Display Module, for Project OLED Screen

Free shipping on orders over $29.99

$9.15

$ 3 .99 $3.99

In Stock
  • Ultra low power consumption: The display makes its own light, no backlight is required, which will reduce the power required to run the OLED. So the power consumption is ultra low (far lower than TFT, LCD and other technologies).
  • High resolution: 128 * 64 (same as the LCD12864, but this product's sharp is more intensive).
  • The display has high contrast, extremely wide viewing angle and extremely operating temperature.
  • Wide voltage support: no need to modify, direct support 3.3V ~ 5V DC.
  • No backlight needed, the display unit can emit light.


Description:
This display module is made of 128x64 pixels, diagonal is only 1.3 inch.The controller ic SSH1106, communicates via IIC/4-wire serial interface. The power consumption is ultra low due to no backlight needed.
Features:
No backlight needed, the display unit can emit light. High resolution: 128 * 64 (same as the LCD12864, but this product's sharp is more intensive). Wide voltage support: no need to modify, direct support 3.3V ~ 5V DC. The display has high contrast, extremely wide viewing angle and extremely operating temperature. Ultra low power consumption: The display makes its own light, no backlight is required, which will reduce the power required to run the OLED. So the power consumption is ultra low (far lower than TFT, LCD and other technologies).
Spec:
Size: 1.3 inches
Control chip: SSH1106
Resolution: 128 * 64
Display area: 29.4 * 14.7 mm / 1.16 * 0.58in
Physical size: 35.4 * 33.7 mm / 1.39 * 1.33in
Interface type: 4-wire Serial Peripheral Interface, IIC interface
Number of pins: 7pin
Operating temperature: -40-70 ℃
Working voltage: 3.3-5V
Package weight:15g
Package List:
1 x 1.3inch display



Bob in OKC
Reviewed in the United States on November 29, 2023
I haven't tried to use this yet. The 2-star review is based on two things that are visibly disappointing.1. The header pins are soldered at a slight angle. Admittedly, a minor complaint.2. More importantly, I was expecting to use this display on an I2C bus, with several other devices. But was surprised to find that it is made to be driven by SPI; not I2C. This was not disclosed in the product description.