Your cart is empty.
Your cart is empty.Set of 3 RED Pinpointer Protectors - Fits Minelab Pro-Find 15, Pro-Find 20, Pro-Find 35 and Pro-Find 40 pinpointers. Please note: Pinpointer shown in photos is not included and is being used for demonstration purposes only. You will receive 3, 60mil thick, RED, 1.5 inch tip protectors! Prolong the life of your Minelab Pro-Find 15, 20 or 35 pinpointer! Easy to install. Very durable. Does not limit the detection ability.
Terry Ezell
Reviewed in the United States on January 19, 2025
Loved it. Will buy it again when needed.
John
Reviewed in the United States on September 25, 2024
Quality product. It does not affect sensitivity. Quick delivery. Great value for the money. I did put the end cap in hot water prior to install. Slipped right on and molded itself to my pinpointer. I have many hours using 1 of them and have had no issues with it coming off. It also has minimal signs of wear and my ground is pretty rough.
Kindle Customer
Reviewed in the United States on June 30, 2024
Pinpointer tips extend the lifetime of your valuable pinpointing tool.
Rich Feimer
Reviewed in the United States on June 17, 2024
Protect your pinpointer with these!! They are very durable. Helps make pinpointer more visible Al well!
Mark
Reviewed in the United States on February 24, 2024
I bought this for a minelab 40 series pinpointer. Fits snuggly and doesn't come off unless you work at it. I'm sure it would fit great on other pinpointers but can't say for sure because I've only tried it with the one I have. It's the same material as some tool handles. Kind of a rubbery material. I would recommend this to anyone wanting to protect the end of their expensive pinpointer.
Dave
Reviewed in the United States on February 12, 2024
It's tight, but, yeah, it fits. Wish it was longer to cover more of the sides. Doesn't appear to effect detection.
Jack Gosda
Reviewed in the United States on October 11, 2024
These fit perfectly as described. Did not effect the use of the pinpointer
Recommended Products
