Shopping Cart

Your cart is empty.

Your cart is empty.

PHILIPS ICN-2P32-N BALLAST

Free shipping on orders over $29.99

$17.80

$ 8 .99 $8.99

In Stock
  • Made in Mexico
  • Package length : 18.0"
  • Package width : 18.0"
  • Package height : 21.0"


Electronic Ballast, Start Type Instant, Lamp Type T8 Lamps, Ballast Family Centium(TM), Number of Lamps 1 or 2, Voltage 120/277, Light Output Normal, Min. Starting Temp. 0 Degrees F, Amps AC 0. 50 to 0. 21, Input Watts 59


Ruben Aydinyan
Reviewed in the United States on March 1, 2025
Great ballast. Works as expected. Easy to install.
Customer
Reviewed in Canada on January 26, 2025
Worked great.
Dylan
Reviewed in the United States on January 22, 2025
A lot of things are intimidating until you really get in there, especially involving electricity. You'll really only need a few things and about 10-15 minutes.~Ladder~Head lamp~Screwdriver~Wire cutters~Wire nuts~Maybe electrical tapeHeadlamp on, turn off the switch in question, remove the plastic cover, expose the black/white/green connectors. Mine were behind a removable panel but you may need to drop the light from the ceiling a bit to get access. The ballast comes with much longer wire than you'll need so you can trim accordingly. Hold the new ballast near the old one to get an idea where everything will need to route. Snip the red/blue wire close to the old ballast to give you enough to work with. Remove old ballast, put the new one in it's place. From here, it is really just plugging colored wires together. If you have two blue wires but only need one, snip off the extra and tape the exposed end. I topped everything off with new LED bulbs and the garage is MUCH brighter. Just getting he bugs out of the cover helped too...
Jim O
Reviewed in the United States on September 27, 2024
Item fits perfectly and works as it should.
Customer
Reviewed in the United States on September 24, 2024
Ballast was easy to replace. Works as it should.
D. Herrick
Reviewed in the United States on August 30, 2024
When my garage light stopped working I dreaded what it might be. Do I pay an electrician $300 to fix it? I then realized it was probably nothing more than a bad ballast. A quick check with voltmeter confirmed my suspicions. I ordered one and it arrived two days later. I installed it in less than 10 minutes. Light works great now.
Stephen M. Grimm
Reviewed in the United States on August 19, 2024
This ballast was an exact replacement for the one in my fluorescent light fixture. It fits perfectly, was fairly easy to install and works perfectly.
chris tester
Reviewed in Canada on June 19, 2024
Works as it should, have to see how long it will last. I use it for my converted tube light to LED
Axle
Reviewed in the United States on December 13, 2024
Well priced ballast for by two t8 lamp system.
Ted
Reviewed in Canada on November 18, 2024
Good quality, was exactly what I needed.
R. Montemiglio
Reviewed in Canada on October 29, 2024
Perfect replacement for an old style ballast, compatible with the new led neon replacements.
Bill H.
Reviewed in Canada on April 21, 2024
This item was as described. It is an exact replacement for the ballast in my ceiling light.Easy to install, has proper installation instructions and works as is should.It was delivered earlier than expected and was packaged properly.I recommend this item to anyone that needs to replace the ballast in their lighting fixture.
LP
Reviewed in the United States on October 31, 2022
I had replaced an OEM ballast with the Phillips. Basically, it was fine. The only reason for not giving 5 stars is that, even though instant on, there was a very quick flicker. It really was no big deal and would normally be fine, it just happens that it was next to a light with no flicker so it may it too obvious. If it was by itself, absolutely a great buy and good replacement.