Your cart is empty.
Your cart is empty.This igniter is a replacement for Carrier, Bryant, Payne LH33WZ511, LH33WZ515, LH680012, LH680014. Flame sensor for Hot Surface Ignition (H. S. I. ) systems Can be mounted remotely on multiple burners or adjacent to igniter on other applications For use with spark ignition and flame sensing High quality alumina ceramic insulator High temperature kanthal flame rod material that can withstand 1800°F Features 45 Degree For use with Carrier LH33ZS004 igniter Used on these Bryant & Carrier models: 330AAV, 330JAV, 333BAV, 333JAV, 398AAV, 58DHC, 58DXC, 58PAV, 58SSC, 58SXC, 58TUA and 58WAV
Anthony K
Reviewed in the United States on March 13, 2025
Fits perfectly. Correct connector. Works perfectly.
R. Hernandez
Reviewed in the United States on January 2, 2025
I used this on my Carrier furnace and the fit is great. The sensor is a little bit longer than the original, but it does not affect it in any way.
A. Mathew
Reviewed in the United States on December 6, 2024
My furnace kept cycling off at random times before room temp reached the set thermostat level. It was subtle bc it didn't turn off immediately after turning on like many other folks reported here but it would run for an hour or more but then will eventually just cycle off. I cleaned the old flame sensor and put it back but that did not do the trick. Did some research and stumbled on this and replaced old one with this. Instant fix to the problem! Furnace now runs as it should and maintains the set temperature without flames turning off and fan just blowing cold air like it did before. So glad I found it. Saved a lot of $$$ compared to a HVAC tech call.
tailu66
Reviewed in the United States on December 29, 2024
My furnace was starting and stopping over and over. I cleaned the old one with steel-wool and that seemed to help. I opted to get a new one. This flame sensor matches the original on my Carrier Weathermaker 8000
Mark L. Smith
Reviewed in the United States on November 6, 2024
You should have a spare, you don't want to "need" one in January. This worked perfectly on my 1999 Lennox furnace.
Mr. 2025
Reviewed in the United States on November 18, 2024
Item as described. Easy to install. Shipment as expectation on time for the maintenance project. Thanks,
Walt
Reviewed in Canada on September 17, 2023
Easy to install. Works great.
lexemdys
Reviewed in the United States on July 31, 2023
The Flame Sensor is a quick and easy fix. If your furnace kicks on and off, you can clean off the flame sensor with a little high grit sandpaper to see if it fixes your problem. I've gone another season doing this. These replacements are cheap and easy to install. Plenty of videos out there. Click off the power switch to your furnace, pull off your old one, clean it, record the model number to order a replacement then reinstall.
Scott
Reviewed in Canada on January 30, 2022
Worked good
Dymetro
Reviewed in Canada on January 23, 2021
Not much to say. It is a pierce of wire surrounded by ceramic material that is inserted into the flame. I bought it as a spare
Customer
Reviewed in Canada on December 20, 2019
Order was exactly as described. Thanks.
Mike Trierweiler
Reviewed in the United States on February 12, 2018
Just the right part for the job and it arrived in just a couple days. Good job to all!!
Scott
Reviewed in Canada on November 1, 2018
Product was just as shown in the picture. It was easy to install and worked great.
Recommended Products
