Terry Ferris
Reviewed in the United States on August 28, 2024
Good product
サソリ男
Reviewed in Japan on December 25, 2022
The media could not be loaded.
odie
Reviewed in the United States on September 17, 2021
what can I say. These things work. adjusting points is a pain. Make sure your coil is matched. The old one is likely the wrong ohms since it was for points and condensor.
trae161
Reviewed in the United States on May 20, 2019
Package was damaged when I got it and it is way too complicated for me to install it.
JC
Reviewed in the United States on October 9, 2019
Bought this for my fiat. Its been sitting for about 30 years in a garage. Needed to replace all the ignition components. Decided to go with this simple solution. Fired right up. Install was easy. Directions were clear and YT has a few videos on the subject to clear up any murky points.
Bruce
Reviewed in the United States on October 31, 2018
It fit right in my 1976 Alfa Romeo Spider's Marelli S103BA distributor easily (distributor REMOVED from the car). After re-timing, the car is running better than ever!! APPLICATION NOTE: I don't actually fire the coil with the MR-LS1 directly. Instead, the MR-LS1 serves as a magnetic pick-up for my PerTronix Digital HP box, which fires the coil, governs over rev situations, provides a tachometer feed and diagnostics (as well as multispark).
L. E. A. M
Reviewed in the United States on July 26, 2013
It works great in my 1974 Alfa Romeo Giulia that I use for Vintage Racing Purposes.Following the instalation instructions and watching the videos available in You Tubeis really easy to install the Pertronix.
Joseph
Reviewed in the United States on February 10, 2013
Its pretty straight forward to install. Remove distributor cap, remove points and condensor - then you have to figure out where to put the base, but there aren't many options. This MR-LS1 fit my Alfa Romeo Spider 2.0L just fine. I have the Marelli 103ba distributor. The 103b requires a different MR-model #, I believe.I look forward to getting my electronic ignition's worth!
Anthony M.
Reviewed in the United States on November 13, 2013
Have had problems with it and Pertronix thinks it needs to be returned to them for testing. Never had problems with one of these before but this one maybe faulty. I've bought many and resold them for years.