Your cart is empty.
Your cart is empty.Product Description
The duct connector flange is mainly used to connect the duct hose (not included) to an output port through a bolted connection. Widely used on the home, kitchen, bathroom, garage, and office. Suitable for this area which needs a ventilation system.
Advantage
1. The connector is made of ABS plastic material, which has good corrosion resistance and temperature resistance and is durable.
2. The connector base has screw mounting holes, which can be directly fixed on the wall with screws without drilling on the connector , and the installation is convenient.
Instruction
For ducted ventilation systems, mount the duct connector to the wall and attach your exhaust hose to our duct connector.
NOTE:
Please confirm the outer diameter of the connector before placing an order.
George
Reviewed in the United States on January 4, 2025
Works great
John C Brown
Reviewed in the United Kingdom on January 12, 2025
These have a slight tapper. They fit the duct very nicely, unlike others I have used.
maxime bergeron
Reviewed in Canada on September 25, 2024
Trop petit
Chris Harrell
Reviewed in the United States on August 17, 2024
Made well, thick enough for rigidity and support of hoses attached, if weight of hose is hanging upon. Good plastic composition.
Danny B
Reviewed in Canada on July 28, 2024
Opening was a alot smaller than the 8inch flex ducting I was trying to connect to it. Went with something a bit larger and in metal. Good if your not too picky
simeon
Reviewed in the United States on June 10, 2024
I am building a ventilation station for painting miniatures. this item was what I was looking for and works great.
Julz
Reviewed in the United States on February 18, 2024
Perfect piece to finish venting my laser engraver through the wall in my work room.
michelle
Reviewed in the United States on November 7, 2024
Bought these for my Peterbilt 389 they work great BUT They do NOT come with the air fittings to connect to to the air lines. Had to go buy the fittings. The Peterbilt factory airbags have the fittings molded into them.
D. Bain
Reviewed in Canada on November 6, 2024
I needed something sturdier for a vent system and found these just a little too light. Would probably be fine in light duty ventilation system.
Josef
Reviewed in the United States on November 20, 2024
No complaints, used it for a break duct set up
Korey Y
Reviewed in the United States on January 24, 2024
Better than just trying to seal around a round hole. Recommend using large washers
KP
Reviewed in the United States on April 25, 2024
These are 3” at the collar but are smaller diameter at the beginning of the collar.I had to cut off most of the neck to fit my 3” hose.These are quite thin material but will do fine for my bathroom fan in my trailer.
Recommended Products
$55.99
$ 28 .99 $28.99