Your cart is empty.
Your cart is empty.Npt Pipe Die Hex Die Carbon Steel Rethreading Die 3/8-18
marvin barkley
Reviewed in the United States on February 8, 2025
On time
The Sommerfeld’s
Reviewed in the United States on February 25, 2025
Very functional fit & design for the money. Did the job with no problem!
Spence
Reviewed in the United States on February 17, 2025
only good for plastic!!!
Raynald
Reviewed in Canada on September 29, 2024
Nettoyage de filet d'une pièce
Customer
Reviewed in the United States on December 29, 2024
It came on time and did the job for me,I bought this only for one pipe to thread so I don't know about its durability.
CC
Reviewed in the United States on December 29, 2024
Works as it should, Just needed it to chase threads.
Old Car Doc
Reviewed in the United States on October 23, 2024
used for making pipe plugs a bit smaller for shallow threaded holes .
Joseph
Reviewed in the United States on September 17, 2023
We used this die at a machine shop to clean up some steel threads and it did a fine job. Just make sure to use a good tapping oil. No issues with the product and it was many times cheaper than I could find this size thread die elsewhere. I can’t say how durable it would be long term but in our case it was great.
DB
Reviewed in the United States on July 14, 2023
I bought this as the threads were stripped on the pipe end. There should be enough pipe to cut the bad threads off with a hacksaw. Place the tap on the end of the pipe. Use a big crescent wrench for leverage take your time to cut the threads. Go around a few times backing off and going forward it's gonna be like this til you get the tap down the pipe. After you get a few threads done take the tap off and lubricate the pipe I used Dawn dish soap straight on the pipe put the tap back on and work it til the tap clears the pipe. You will know the tap is tapered and tap it until the tap is flush with the pipe end. Done.
Recommended Products
$10.53
$ 4 .99 $4.99